Re: Car flied up then went out of the track

Thanks! This is very helpful.

Best,
Yunzhu


> -----Original Messages-----
> From: "Bernhard Wymann" <[email protected]>
> Sent Time: 2016-11-16 14:46:03 (Wednesday)
> To: "Yunzhu Li" <[email protected]>
> Cc: [email protected]
> Subject: Re: [Torcs-users] Car flied up then went out of the track
> 
> Hi Yunzhu
> 
> Yes, these conditions can lead to this:
> - damage > 10000
> - car run out of fuel and is not moving
> - car did not complete the lap within a reasonable time (with an average 
> speed of 10m/s and some "bonus time)
> - car did not clear a penalty within the required number of laps (can 
> just happen in pro mode, semi pro is default for robots)
> 
> See raceengine.cpp:
> http://torcs.cvs.sourceforge.net/viewvc/torcs/torcs/torcs/src/libs/raceengineclient/raceengine.cpp?revision=1.19.2.23&view=markup&pathrev=r1-3-1
> 
> Kind regards
> 
> Bernhard
> 
> 
> On 16.11.2016 22:15, Yunzhu Li wrote:
> > Hi Bernhard,
> >
> > Is there any other cases that could lead to this situation?
> > I am pretty sure that there is no damage, yet the car is still been taken off the track by the (invisible) crane.
> >
> > Thanks!
> > Yunzhu
> >
> >
> >> -----Original Messages-----
> >> From: "Bernhard Wymann" <[email protected]>
> >> Sent Time: 2016-11-14 14:11:03 (Monday)
> >> To: "Yunzhu Li" <[email protected]>, [email protected]
> >> Cc:
> >> Subject: Re: [Torcs-users] Car flied up then went out of the track
> >>
> >> Hi
> >>
> >> Yes. If the car is totally broken (damage > 10000) it stops, and the
> >> virtual (invisible) crane takes it off the track to the side.
> >>
> >> Kind regards
> >>
> >> Bernhard
> >>
> >> On 14.11.2016 11:37, Yunzhu Li wrote:
> >>> Dear all,
> >>>
> >>> Has anyone encountered the following issue?
> >>>
> >>> I was writing a robot for torcs. After moving normally for a while, the
> >>> car suddenly flied up for a certain distance, then moved horizontally
> >>> towards the outside of the track, then dropped down.
> >>>
> >>> Any ideas of how to solve this? I am using torcs 1.3.4 with provided SRC
> >>> patch.
> >>>
> >>> Thanks in advance.
> >>>
> >>> Yunzhu
> >>>
> >>>
> >>> ------------------------------------------------------------------------------
> >>>
> >>>
> >>>
> >>> _______________________________________________
> >>> Torcs-users mailing list
> >>> [email protected]
> >>> https://lists.sourceforge.net/lists/listinfo/torcs-users
> >>>
> >>
> >>
> >> ------------------------------------------------------------------------------
> >> _______________________________________________
> >> Torcs-users mailing list
> >> [email protected]
> >> https://lists.sourceforge.net/lists/listinfo/torcs-users
> >
> >
> > ------------------------------------------------------------------------------
> > _______________________________________________
> > Torcs-users mailing list
> > [email protected]
> > https://lists.sourceforge.net/lists/listinfo/torcs-users
> >
> 


------------------------------------------------------------------------------