RE: : application ID and no end ...

Hi all,

I agree that in most practical scenarios realm based routing would not be used for an ASR.
However, this is nowhere stated on RFC 3558 - so we should not rule that out.

Furthermore, instead of demading complicated considerations in this respect from each application designer, wouldn´t it be easier to state that as a rule the app-ID should be used for all commands within a Diameter session related to that application?

Thomas

> -----Original Message-----
> From: [email protected] [mailto:[email protected]] 
> On Behalf Of [email protected]
> Sent: Tuesday, November 29, 2005 1:53 PM
> To: [email protected]
> Subject: RE: [AAA-WG]: application ID and no end ...
> 
> 
> Hi,
> 
> > ASR is a common diameter message applicable to any 
> > application and since the Destination-Host is used for 
> > routing I don't see how the message can reach the wrong 
> > client. So, ASR can use application id '0'IMHO.
> 
> I think so too.
> 
> It seems that in some cases the application-id should
> be changed even if there is no changes to the command
> but in other cases this is not needed.
> 
> I think it might be difficult to find a rule that can
> be applied in all cases.
> 
> I think the main thing is that the Diameter Application
> defines what app-id is used in each case taking in account
> the possible error cases etc.
> 
> 
> BR,
> Mikko
> 
> 
> > -----Original Message-----
> > From: [email protected] [mailto:[email protected]] 
> > On Behalf Of ext STURA Marco Consultant
> > Sent: 29 November, 2005 14:21
> > To: Loughney John (Nokia-NRC/Helsinki); 
> > [email protected]; [email protected]
> > Cc: [email protected]
> > Subject: RE: [AAA-WG]: application ID and no end ...
> > 
> > John,
> > 
> > but ASR is mainly sent by a server to a specific client using 
> > the Destination-Host. The server must know where the Diameter 
> > session to be torn down is actually running, in which client.
> > 
> > ASR is a common diameter message applicable to any 
> > application and since the Destination-Host is used for 
> > routing I don't see how the message can reach the wrong 
> > client. So, ASR can use application id '0'IMHO. 
> > 
> > Regards
> > Marco
> > 
> > -----Original Message-----
> > From: [email protected] [mailto:[email protected]] 
> > On Behalf Of [email protected]
> > Sent: Tuesday, November 29, 2005 1:06 PM
> > To: [email protected]; [email protected]
> > Cc: [email protected]
> > Subject: RE: [AAA-WG]: application ID and no end ...
> > 
> > Thomas,
> >  
> > If you are trying to reach a server that implements the new 
> > application, then any commands that form part of that 
> > application should use the new Application ID.  If the new 
> > Application ID is not used, then the messages could not be 
> > routed properly.
> >  
> > Of course, the drawback for this is, all relays and proxies 
> > would need to be updated to enable them to route messages for 
> > the new Application ID.  This is why it is not recommended to 
> > create new applications unless absolutely necessary.
> >  
> > John
>