Re: draft-ietf-adslmib-gshdslbis-11.txt

Hi Clay,

Thank you for the message.  We have updated the file to reflect the following 
change: "Message ID 129, Octet 12."  Please let us know if you have any 
questions.

Alba for the RFC-Ed


> Hi,
> 
> Sorry to bother you again.  Mathias Riess, at Infineon, just sent an
> Email to the Adslmib List to communicate a minor error in one of the
> reference clauses.  In hdsl2ShdslInvVendorEOCSoftwareVersion, {
> hdsl2ShdslInventoryEntry 5 }, the "Message ID 130, Octet 12," should
> state "Message ID 129, Octet 12."  I checked the specification that was
> referenced and verified that the ID should be 130.  If it is not too
> much trouble, please make the correction when you open the file to
> assign an RFC number.
> 
> Thank you so much!
> 
> Best Regards,
> Clay Sikes
> 
> 
> On 6/30/2005 6:52 PM, Alba Regalado-Palacios wrote:
> <blockquote cite="[email protected]"
>  type="cite">
>   <pre wrap="">Hi Clay,
> 
> My apologies for not answering sooner.  Thank you for forwarding the XML 
> source file.  This e-mail acknowledges that the RFC Editor has received it.  
> We will close the space in line 605 as you requested.
> 
> Thank you,
> Alba for the RFC-Editor
> 
> 
>   </pre>
>   <blockquote type="cite">
>     <pre wrap="">RFC Editor,
> 
> On 6/22/2005 I attached the XML file to an Email.  I didn't get any 
> confirmation that you received the file and was wondering if it was 
> received and if you had everything you needed.  Please let me know one 
> way or the other; I'll be happy to resend the file or do anything else 
> to help.
> 
> Also, this is no big deal, but today I noticed some minor nit in the XML 
> source that does not cause any problems in rendering the .txt, but 
> prevents the xml file from being viewed in a Web browser (Firefox).  On 
> line 605, there is an extra space the the termination of a comment that 
> causes Firefox to not open the XML file because it considers the extra 
> space to be an "XML Parsing Error: not well-formed" situation.  To 
> correct the issue, the extra space need to be removed on line 605 as 
> follows:
>    OLD 605: &lt;/section&gt;   &lt;!-- title="Structure" -- &gt;
>                                                   ^
>    NEW 605: &lt;/section&gt;   &lt;!-- title="Structure" --&gt;
> 
> If it's not any trouble, it would be cool if you could make that change 
> when you open the file to assign an RFC number.
> 
> Thanks,
> Clay Sikes
>     </pre>
>   </blockquote>
>   <pre wrap=""><!---->
>   </pre>
> </blockquote>
> </body>
> </html>
> <pre>
> -- Paradyne Mail --