Re: Discussion of TSSi
| Newsgroups | gmane.ietf.adslmib |
|---|---|
| Message-ID | <OF4C809501.525711A3-ONC2257096.002B5CCE-C2257096.002CFB06@ecitele.com> |
Hello Chen Jian,
Please check ITU-T 05/2003 "Table 7-23/G.997.1 – Line test,
diagnostics and status parameters".
Here the TSSpsds as defined in 7.5.1.21.5 is defined as a Read Only
parameter.
The TSSpsus as defined in 7.5.1.21.6 is defined as a Read Only parameter.
These parameters are clearly stated as Read-Only
parameters and defined in the Status table.
Regards,
Menachem
Chen Jian
<chanboy@huawei. To: [email protected], [email protected]
com> cc: [email protected]
Sent by: Subject: [Adslmib] Discussion of TSSi
adslmib-bounces@
ietf.org
10/10/2005 11:38
Hello Moti & Menachem,
I have a question about the newly added node adsl2SCStatusTssi placed in
the
adsl2SCStatusTable and having Read-Only access.
I think the TSSi may be a writable configration node which can be placed in
profile table. The user can control the
Shaping through parameters.
In the G992.3 & G992.5 , ITU-T wrote:
"The tssi values depend on CO–MIB settings (see ITU–T Recommendation
G.997.1 [04]) and
on local capabilities and are exchanged in the G.994.1 Phase."
Best Rgds,
Chen Jian
-----------
Regards,
Chen Jian
Huawei Technologies Co.,Ltd _______________________________________________
Adslmib mailing list
[email protected]
https://www1.ietf.org/mailman/listinfo/adslmib
_______________________________________________
Adslmib mailing list
[email protected]
https://www1.ietf.org/mailman/listinfo/adslmib