Comment: draft-jacpra-bmwg-pmtest-02
Bharat M Gaonkar <[email protected]>
| Newsgroups | gmane.ietf.bmwg |
|---|---|
| Message-ID | <BN6PR05MB28523450FACFBF89AE87D43FBFBC0@BN6PR05MB2852.namprd05.prod.outlook.com> |
Hi Authors, I would like to support your draft. I had a comment though explicitly with respect to delay measurement. 5.1 Y.1731 Two-way Delay Measurement Test procedure Basic Testing Objective Check the round trip delay of the network in different conditions of traffic load in the network. Test Procedure Configure a layer 2 point-to-point service between PE1 and PE2. Configure Y.1731 Two way delay measurement over the service.Observe the delay measurement in the following conditions of traffic in the network a. Send 80% of Line-rate traffic with different priorities and frame size. b. Send 40% of Line-rate traffic with different priorities and frame size. Can we elaborate in the draft the point a and b more. I believe you mean for each priority all frame sizes should be selected? Also can we add some variations in traffic type (IP, L2 Control, transit L2 control ...) This gives a different load on the box and hence impacts delay measurement. Thanks, Bharat _______________________________________________ bmwg mailing list [email protected] https://www.ietf.org/mailman/listinfo/bmwg