RE: WG Last Call:dratf-ietf-bridge-ext-v2-03.txt

John,

Okay, changed.

-Dave

-----Original Message-----
From: John Flick [mailto:[email protected]] 
Sent: Friday, January 07, 2005 11:00 PM
To: Levi, David [SC100:323:EXCH]
Cc: Congdon, Paul T; [email protected]
Subject: Re: [Bridge-mib] WG Last Call:dratf-ietf-bridge-ext-v2-03.txt


Dave,

Your changes look fine except for one nit.

David Levi wrote:
>  > 4. The description of dot1qPortAcceptableFrameTypes is no longer
>  >     accurate with protocol VLANs.
>  > DBL> Can you suggest how to change the text?
> 
> In the first paragraph of the description, replace "assigned to the 
> PVID
> for this port" with "assigned based on the PVID and VID Set for this
port".
> 
> DBL>  Your suggested text doesn't indicate to what the frame is being
> assigned.
> DBL>  The old text did indicate this.  How about 'assigned to a VID
> based on the
> DBL>  port's PVID and VID settings'?

I think I would put change this to "assigned to a VID based on the PVID and
VID Set for this port."  The "VID Set" term is the protocol VLAN term I was
trying to pull in here.

John

_______________________________________________
Bridge-mib mailing list
[email protected]
https://www1.ietf.org/mailman/listinfo/bridge-mib