CAP-12-a: 9.6 VQUERY Component - QUERYID/NAME

In CAP-12-a, under Section 9.6 VQUERY Component is written:

                                             Normally "NAME" and
   "QUERYID" properties are used when looking for a correct stored
   "VQUERY" component, or when storing a "VQUERY" component.

Im curious to know when we decided that the NAME property was to be used 
for identifying the VQUERY? 

If its just the "localizable display name" then what use is it in looking 
for the particular VQUERY?  Isn't that the sole role for the QUERYID 
property?  If not, when is NAME _not_ used (since the text says 
"Normally"...)?

Since later text says:

   For a search, if the "TARGET" property is supplied in a "VQUERY"
   component, then the CS is to search for the query in the calid
   supplied by the "TARGET" property value.

I suspect that the 1st bit above is just poor phrasing and there is no 
actual intent of using NAME in some unspecified combination with QUERYID. 
However I dont want to second guess Dougs intent here. 

Bruce
===========================================================================
Bruce Kahn                                INet: 
[email protected]
Messaging & Collaboration                 Phone: 978.399.6496
IBM Software Group                         FAX: and nothing but the FAX...
Standard disclaimers apply, even where prohibited by law...