RE: FlowId and FlowIdOrAny
"Wijnen, Bert (Bert)" <[email protected]> Tue, 21 Jan 2003 13:09:45 +0100
| Newsgroups | gmane.ietf.rap,gmane.ietf.diffserv |
|---|---|
| Message-ID | <7D5D48D2CAA3D84C813F5B154F43B155BADE65@nl0006exch001u.nl.lucent.com> |
Ok, good, cause I was surprised to see a -1 in an Unsigned32. Now... if we do this, then this could still be used by the framework pib. However, for the diffserv-mib it would mean they must deprecate a current object and create a new one (switching from Unsigned to Integer32 causes a change on the wire!). The solution presented earlier could be considered as a bug fix and would not require the diffserv-MIB to deprecate the existing object Thanks, Bert > -----Original Message----- > From: Juergen Schoenwaelder [mailto:[email protected]] > Sent: dinsdag 21 januari 2003 11:24 > To: [email protected] > Cc: [email protected]; [email protected] > Subject: FlowId and FlowIdOrAny > > > > I changed the subject line and fixed the proposed TC. So here is where > I think we are. I have also reduced the CC list and I have added the > diffserv mailing list since diffserv folks should be in the loop I > think. > > FlowId TECTUAL-CONVENTION > DISPLAY-HINT "d" > STATUS current > DESCRIPTION > "The flow identifier in an IPv6 header that may be used to > discriminate traffic flows." > REFERENCE > "RFC 2460" > SYNTAX Integer32 (0..1048575) > > FlowIdOrAny TECTUAL-CONVENTION > DISPLAY-HINT "d" > STATUS current > DESCRIPTION > "The flow identifier in an IPv6 header that may be used to > discriminate traffic flows. The value of -1 is used to > indicate a wildcard, i.e. any value." > REFERENCE > "RFC 2460" > SYNTAX Integer32 (-1 | 0..1048575) > > Open issues: > > - Is the flow identifier the same as the flow label? I guess so. If > this is true, then we should probably use the TC names FlowLabel > and FlowLableOrAny and also change the wordings in the description > clause. > > - The name of the MIB modules which will contain these definitions. > > - Since Fred kind of said that the diffServMultiFieldClfrFlowId > object should have had a wildcard, can we agree that this is > actually a bug in RFC 3289 which will be fixed by using FlowIdOrAny > in the next revision of the DIFFSERV-MIB? > > /js > > -- > Juergen Schoenwaelder <http://www.informatik.uni-osnabrueck.de/schoenw/>