RE: RessourceId/arcIndex, alarmModelIndex/arcAlarmType

"Lam, Hing-Kam (Kam)" <[email protected]> Fri, 14 Oct 2005 14:38:05 -0400
Newsgroups gmane.ietf.disman
Message-ID <E4BB443436F22D4AB9E84B06AB7C4CE0142F5D4E@nj7460exch004u.ho.lucent.com>
Hi Andreas,

In response to your question:
> ... Is there a way to show the manager the possible
> alarm-ressource combinations? Perhaps with the 'arcTable' - without
> turning all alarm reporting off?

The arcTable is not for showing all the possible alarm-ressource combinations of a managed system. The table is only for specifying those alarm-ressource combinations that one would like to turn off their reporting when they raise. The table uses arcIndex and arcAlarmType for specifying such combinations.

Regards,
Kam 

  

> -----Original Message-----
> From: [email protected] 
> [mailto:[email protected]]On Behalf
> Of Sharon Chisholm
> Sent: Thursday, October 13, 2005 2:11 PM
> To: [email protected]
> Subject: RE: [Disman] RessourceId/arcIndex, 
> alarmModelIndex/arcAlarmType
> 
> 
> hi
> 
> Are the resources not able to send alarms or are these alarms just not
> modelled in the MIB? For the first, generally this isn't reported. For
> the second, the simplest thing would be to model them, unless I am
> missing something.
> 
> Kam can answer your question about whether ARC can be used to report
> that alarms won't come from these resources, but this does 
> seem to me to
> be suggesting that the resources are in maintenance mode, 
> which does not
> sound like the correct approach.
> 
> Sharon
> 
> -----Original Message-----
> From: [email protected] 
> [mailto:[email protected]] On Behalf
> Of Politze, Andreas
> Sent: Wednesday, August 24, 2005 10:37 AM
> To: [email protected]
> Subject: [Disman] RessourceId/arcIndex, alarmModelIndex/arcAlarmType
> 
> 
> Hi,
> 
> at first I have to apologize for sending to rfc-editor before using
> disman mailing list.
> 
> I have a questions using Alarm-MIB and ARC-MIB:
> The problem is that the modelled alarms are not supported by all
> ressources. Is there a way to show the manager the possible
> alarm-ressource combinations? Perhaps with the 'arcTable' - without
> turning all alarm reporting off?
> --
> Thanks and best regards
> Andreas Politze
> KEYMILE GmbH
> www.keymile.com
> 
> 
> 
>