Syslog Protocol document and Alarm MIB

Since the Alarm MIB was done in this WG, you may want to
take a look at section 6.2.1.1 of document 
   draft-ietf-syslog-protocol-17.txt

It says:

   6.2.1.1.  Relation to Alarm MIB

   The Alarm MIB RFC3877 [11] defines ITU perceived severities which are
   useful to be able to relate to the syslog severities, particularly in
   the case where alarms are being logged.  The ITUPerceivedSeverity
   corresponds to a syslog Severity as shown in table 2 below.

              ITU Perceived Severity      syslog SEVERITY
              Critical                    Alert
              Major                       Critical
              Minor                       Error
              Warning                     Warning
              Indeterminate               Notice
              Cleared                     Notice

           Table 3. ITUPerceivedSeverity to syslog SEVERITY mapping.

I think this is OK. But wanted to make sure we have all had a chance to
look at it and make a comment if you think it is not OK. Probably best to
then also copy such comment to the [email protected] mailing list.

Bert