Re: Extending UPDATE to add/remove zones
Mark Andrews <[email protected]>
| Newsgroups | gmane.ietf.dnsext |
|---|---|
| Message-ID | <[email protected]> |
In message <[email protected]>, Jay Daley writes : > > On 17/10/2013, at 9:47 AM, Mark Andrews <[email protected]> wrote: > > > > > In message <[email protected]>, Jay > Daley writes > > : > >> Thanks to all those that replied. I've summarised and responded to > the point > >> s below: > >> > >> > >> 1. The restriction on FQDNs is too complex and there's no problem > with provi > >> sioning multiple zones in multiple packets. > >> > >> I agree and I'll change it so that only one master can be added per > update. > >> I was indeed thinking about zone templating and that's not a DNS > issue. > >> > >> > >> 2. Clarify what the ZCLASS needs to be set to. > >> > >> ZCLASS == ANY means delete, ZCLASS != ANY means add. > > > > If you have example.net/in and example.net/hs which example.net are you > > referring to with example.net/any? > > We've already got that problem: > > In UPDATE as it currently exists if you have two different RRs of the > same type and different class in the same zone then which is being > referred to with CLASS == ANY ? A zone, by definition, only contains records of a single class. The zone section specify the class of the zone being operated on. Zone: example.net IN SOA Update: example.net ANY TXT Says delete all example.net IN TXT records. > Jay > > > > > Mark > > -- > > Mark Andrews, ISC > > 1 Seymour St., Dundas Valley, NSW 2117, Australia > > PHONE: +61 2 9871 4742 INTERNET: [email protected] > > > -- > Jay Daley > Chief Executive > .nz Registry Services (New Zealand Domain Name Registry Limited) > desk: +64 4 931 6977 > mobile: +64 21 678840 > linkedin: www.linkedin.com/in/jaydaley > -- Mark Andrews, ISC 1 Seymour St., Dundas Valley, NSW 2117, Australia PHONE: +61 2 9871 4742 INTERNET: [email protected] _______________________________________________ dnsext mailing list [email protected] https://www.ietf.org/mailman/listinfo/dnsext