RE: AS2 XML requirements (was Re: HL7 Standards Process)
Dave Roberts <[email protected]>
| Newsgroups | gmane.ietf.ediint |
|---|---|
| Message-ID | <[email protected]> |
On Wed, 22 Nov 2000, Dick Brooks wrote: > The original EDIINT AS1 draft was restricted to supporting RFC1767 payload > types only. I'll try to be careful about how I phrase this response: the original draft of AS1 may have only referred to a payload of EDI, but that's not a strict requirement, and not the case now. The later (and current) drafts do not specify that the payload MUST be EDI, and I believe that since Terry took over authorship, generic EC payloads are now mentioned, although they may not be highlighted by example. During the rounds of AS1 testing, a Word Document was sent as one of the tests to prove that non EDI data could be handled by both parties. - Dave. PS Can people please trim their posts? -- Dave Roberts Servicing the Online Organisation Principal Technical Consultant http://www.saaconsultants.com/ SAA Consultants Ltd Tel: +44 1752 606000 Fax: +44 1752 606838