RE: I believe that AS2 is now ready to be submitted to IETF as a RFC...

Kyle,
 
If we reference the draft-ietf-compression-XX.txt document, will we have
to wait on it to become a RFC?
 
I seem to recall that IDs can be held up waiting for referenced drafts
becoming RFCs-- Rik, do you remember the rule?
 
Anyway, I would prefer not to make the AS2 ID wait for the compression
draft.
 
Dale Moberg

	-----Original Message-----
	From: [email protected]
[mailto:[email protected]] On Behalf Of Kyle Meadors
	Sent: Wednesday, January 07, 2004 2:30 PM
	To: Rik Drummond; [email protected]
	Subject: RE: I believe that AS2 is now ready to be submitted to
IETF as a RFC...
	Importance: Low
	
	

	The AS2 draft vs. 14 doesn't reference the
draft-ietf-compression-XX.txt document. It probably should be added in
section 6.1 of the AS2 draft in talking about AS2-Version 1.1 and
compression, and then added in 11.0 in the References section.

	 

	Kyle Meadors

	Drummond Group Inc.

	 

	
________________________________


	From: [email protected]
[mailto:[email protected]] On Behalf Of Rik Drummond
	Sent: Wednesday, January 07, 2004 12:45 AM
	To: [email protected]
	Subject: RE: I believe that AS2 is now ready to be submitted to
IETF as a RFC...

	 

	thanks... any more?

		-----Original Message-----
		From: Shan Harter [mailto:[email protected]] 
		Sent: Wednesday, January 07, 2004 12:29 AM
		To: 'Rik Drummond'; [email protected]
		Subject: RE: I believe that AS2 is now ready to be
submitted to IETF as a RFC...

		Perhaps a clarification for the following?

		 

		1. "AS2-Version: 1.1 - Designates those implementations
which support Compression as defined by RFC 3274."

		 

		2. The draft draft-ietf-ediint-as2-14.txt does not
reference draft-ietf-ediint-compression-03.txt. 

		 

		3. draft-ietf-ediint-compression-03.txt does not
reference RFC 3274.

		 

		4. draft-ietf-ediint-as2-14.txt does reference RFC 3274
for compression.

		 

		 

			-----Original Message-----
			From: [email protected]
[mailto:[email protected]]On Behalf Of Rik Drummond
			Sent: Tuesday, January 06, 2004 10:26 PM
			To: [email protected]
			Subject: I believe that AS2 is now ready to be
submitted to IETF as a RFC...

			.. are there any more comments on it before we
do a last call on this list?

			 

			Rik Drummond, Chair EDIINT WG