RE: I believe that AS2 is now ready to be submitted to IETF as a RFC...

+1 Maybe introduce a division in references between normative and
non-normative [if you add a ref to an ID]

	-----Original Message-----
	From: Rik Drummond [mailto:[email protected]] 
	Sent: Wednesday, January 14, 2004 7:46 AM
	To: Dale Moberg; Kyle Meadors; [email protected]
	Subject: RE: I believe that AS2 is now ready to be submitted to
IETF as a RFC...
	
	
	last time that got us on as1, referencing an ID. we will have to
ensure it does not cause a problem this time.

		-----Original Message-----
		From: Dale Moberg [mailto:[email protected]] 
		Sent: Wednesday, January 07, 2004 3:48 PM
		To: Kyle Meadors; Rik Drummond; [email protected]
		Subject: RE: I believe that AS2 is now ready to be
submitted to IETF as a RFC...
		
		
		Kyle,
		 
		If we reference the draft-ietf-compression-XX.txt
document, will we have to wait on it to become a RFC?
		 
		I seem to recall that IDs can be held up waiting for
referenced drafts becoming RFCs-- Rik, do you remember the rule?
		 
		Anyway, I would prefer not to make the AS2 ID wait for
the compression draft.
		 
		Dale Moberg

			-----Original Message-----
			From: [email protected]
[mailto:[email protected]] On Behalf Of Kyle Meadors
			Sent: Wednesday, January 07, 2004 2:30 PM
			To: Rik Drummond; [email protected]
			Subject: RE: I believe that AS2 is now ready to
be submitted to IETF as a RFC...
			Importance: Low
			
			

			The AS2 draft vs. 14 doesn't reference the
draft-ietf-compression-XX.txt document. It probably should be added in
section 6.1 of the AS2 draft in talking about AS2-Version 1.1 and
compression, and then added in 11.0 in the References section.

			 

			Kyle Meadors

			Drummond Group Inc.

			 

			
________________________________


			From: [email protected]
[mailto:[email protected]] On Behalf Of Rik Drummond
			Sent: Wednesday, January 07, 2004 12:45 AM
			To: [email protected]
			Subject: RE: I believe that AS2 is now ready to
be submitted to IETF as a RFC...

			 

			thanks... any more?

				-----Original Message-----
				From: Shan Harter
[mailto:[email protected]] 
				Sent: Wednesday, January 07, 2004 12:29
AM
				To: 'Rik Drummond'; [email protected]
				Subject: RE: I believe that AS2 is now
ready to be submitted to IETF as a RFC...

				Perhaps a clarification for the
following?

				 

				1. "AS2-Version: 1.1 - Designates those
implementations which support Compression as defined by RFC 3274."

				 

				2. The draft
draft-ietf-ediint-as2-14.txt does not reference
draft-ietf-ediint-compression-03.txt. 

				 

				3. draft-ietf-ediint-compression-03.txt
does not reference RFC 3274.

				 

				4. draft-ietf-ediint-as2-14.txt does
reference RFC 3274 for compression.

				 

				 

				-----Original Message-----
				From: [email protected]
[mailto:[email protected]]On Behalf Of Rik Drummond
				Sent: Tuesday, January 06, 2004 10:26 PM
				To: [email protected]
				Subject: I believe that AS2 is now ready
to be submitted to IETF as a RFC...

				.. are there any more comments on it
before we do a last call on this list?

				 

				Rik Drummond, Chair EDIINT WG