RE: Entity Management and Dual IP Stack

Thanks for the reply.=20

It is one logical entity with two IP management addresses  ( one IPv4
and one IPv6), my question is how to configure entLogicalTDomain and
entLogicalTAddress to support both IPv4 and IPv6 for the same logical
entitiy=20

Eduardo

-----Original Message-----
From: Sharon Chisholm [mailto:[email protected]]=20
Sent: Thursday, October 27, 2005 10:26 AM
To: Entmib-wg (E-mail)
Subject: RE: [Entmib] Entity Management and Dual IP Stack

hi

Are you saying it has two IP addresses, or supports both Ipv4/IPv6 or
that it is two logical devices (virtual router, etc)? In the first two
cases you only have one logical devices from the Entity MIB's
perspective.

Sharon

-----Original Message-----
From: [email protected] [mailto:[email protected]] On Behalf
Of Eduardo Cardona
Sent: Thursday, October 20, 2005 10:37 AM
To: Entmib-wg (E-mail)
Subject: [Entmib] Entity Management and Dual IP Stack


I have a question,=20

For an entity with 2+ logical entities (implements entLogicalTable) How
do you define the logical entity if the device has dual stack and is
manageable using both IPs ?=20
Shall it defines a duplicate logical entity for the second
entLogicalTAddress?=20

I mean, in the interest of reflecting entLogicalTable entries? Or is
left vendor dependent?=20

Thanks

Eduardo


_______________________________________________
Entmib mailing list
[email protected]
https://www1.ietf.org/mailman/listinfo/entmib


_______________________________________________
Entmib mailing list
[email protected]
https://www1.ietf.org/mailman/listinfo/entmib