Re: ipv6 was Re: LC model draft draft-ietf-forces-model-07.txt

IP addresses (like MAC addresses) should use the byte[N] construct to 
represent the string of bytes for the address.  (A variable length 
address would use octetstring[N].)  So IPv4 addresses use byte[4], 
and IPv6 addresses use byte[16].

Yours,
Joel M. Halpern

At 03:22 PM 10/25/2006, tom.petch wrote:
>How are ipv6 addresses represented in the data model?  Should there be an
>int128??
>
>Tom Petch
>
>----- Original Message -----
>From: "Patrick Droz" <[email protected]>
>To: <[email protected]>
>Sent: Friday, October 13, 2006 10:36 AM
>Subject: LC model draft draft-ietf-forces-model-07.txt
>
>
> > I would like to issue last call on the model draft. As this is
> > a fairly large document the LC will last for 3 weeks and will
> > therefore end just before the next IETF. It is draft:
> > draft-ietf-forces-model-07.txt
> > and can be found at:
> > http://www.ietf.org/internet-drafts/draft-ietf-forces-model-07.txt
> >
> > A number of people have indicated that if the document is in
> > LC they would thoroughly review the document. I hope people will
> > stick to their promises.
> >
> > Regards,
> > Patrick
> >
> >
> >