FW: EPON-DEVICE-MIB

Message
-----Original Message-----
From: Lior Khermosh [mailto:[email protected]]
Sent: Sunday, February 08, 2004 10:13 AM
To: [email protected]
Subject: RE: EPON-DEVICE-MIB


Jayaprakash,
Thank you for your comments.
I agree that the device modes can not be configure through the MIB so it is
indeed a read-only attribute.
I think that as for OAM mode is is required to receive from a device a state
mode of its OAM where 3 equal options exist - Server client and NoOAM. We
can add the OAM disabling/enabling in addition to that.

Regards,
Lior



  -----Original Message-----
  From: [email protected]
[mailto:[email protected]]
  Sent: Friday, February 06, 2004 6:21 AM
  To: [email protected]
  Subject: EPON-DEVICE-MIB


  Hi Lior

  In the EPON-DEVICE-MIB,

  eponDeviceObjectModes is defined as read-write, should it be a read-only
value instead?

  eponDeviceObjectOamMode is also defined as read-write.
  Will eponDeviceObjectModes suffice to identify if the device is a
oamServer or oamClient? For enabling/disabling the oam we could have a truth
value.

  regards
  Jayaprakash





Confidentiality Notice


The information contained in this electronic message and any attachments to
this message are intended
for the exclusive use of the addressee(s) and may contain confidential or
privileged information. If
you are not the intended recipient, please notify the sender at Wipro or
[email protected] immediately
and destroy all copies of this message and any attachments.