RE: pktcSigPowerRingFrequency description change

Yes, this addresses my conserns.
 
Eugene.

________________________________

From: Sumanth Channabasappa [mailto:[email protected]] 
Sent: Wednesday, October 20, 2004 11:03 AM
To: Eugene Nechamkin; Beacham Gordon-CGB005; [email protected]
Subject: RE: [ipcdn] pktcSigPowerRingFrequency description change


Hi Eugene,
 
 
How about:
 
"The default value for this object is dependent on the primary usage
area of the device. For devices compliant with PacketCable (North
America)  it MUST be set to f20Hz and for devices compliant with
IPCablecom (Europe)  it MUST be set to f25Hz."
 
 
Sumanth

	-----Original Message-----
	From: Eugene Nechamkin [mailto:[email protected]] 
	Sent: Wednesday, October 20, 2004 11:50 AM
	To: Beacham Gordon-CGB005; [email protected]; Sumanth Channabasappa
	Subject: RE: [ipcdn] pktcSigPowerRingFrequency description
change
	
	
	 
	While not disagreeing with the proposal to delete the DEFVAL
clause from the MIB Object definition, I am not completely comfortable
with the fact that IETF MIB draft would make a reference to the document
([PKT-SP-MIB-SIG]) which will be obsolete when draft becomes an RFC (or
soon thereafter). Besides, I am not sure to which extent the mentioning
of compliency with the [PKT-SP-MIB-SIG] or with the [ITU-T-J169] is
unambigous. Not sure presisely what this "compliency" means. What's the
intention here - to say that for MTAs compliant with NorthAmerican-PC
the defval should be f20 but for MTAs compliant with Euro-PC the defval
should be f25Hz ? I think the reference to the compliency should be made
less ambiguous. 
	 
	Eugene.

________________________________

	From: [email protected] [mailto:[email protected]] On
Behalf Of Beacham Gordon-CGB005
	Sent: Tuesday, October 19, 2004 8:48 AM
	To: [email protected]; '[email protected]'
	Subject: [ipcdn] pktcSigPowerRingFrequency description change
	
	
	The following changes are recommended to the description of the
pktcSigPowerRingFrequency object.
	 
	delete: DEFVAL { f20Hz }
	add: This default value for this object MUST be f20Hz for MTAs
compliant to [PKT-SP-MIB-SIG]. The default value for this object MUST be
f25Hz for MTAs compliant to [ITU-T-J169].
	 
	Gordon

_______________________________________________
IPCDN mailing list
[email protected]
https://www1.ietf.org/mailman/listinfo/ipcdn