RE: Size of docsDevSwFilename in draft-ietf-ipcdn-device-mibv2-06.txt

"Jean-Francois Mule" <[email protected]>
Newsgroups gmane.ietf.ipcdn
Message-ID <[email protected]>
(I thought I had sent this but it was stuck in my draft folder, and just saw Rich's note - sorry).

Azlina,
Good point, I forgot that the device mib is *not* a "new" mib and we can't increase the upper bound.
We have a couple of options:
 - do nothing (operators should get their http server hostnames and URL down to 64 chars)
 - keep docsDevSwFilename for TFTP and add a new object docsDevSwFilenameURL for http
   (this has the advantage to leave the DOCSIS implementations intact on this object)
 - deprecate docsDevSwFilename and a new object docsDevSwFilenameURL for tftp and http

Since this new object is moslty required for PAcketCable Standalone MTAs, I'm ok with option 2 above.

Jean-François 

> -----Original Message-----
> From: Azlina Ahmad [mailto:[email protected]]
> Sent: Friday, October 31, 2003 11:01 AM
> To: Jean-Francois Mule
> Cc: Woundy, Richard; [email protected]
> Subject: Re: [ipcdn] Size of docsDevSwFilename in 
> draft-ietf-ipcdn-device-mibv2-06.txt
> 
> 
> Jean-Francois,
>      I believe we have extended the upper bound of a mib
> object in the past :) However, per RFC2578 Section 9 rule (3) 
> defined that "the size in octets 
> of the value may be refined by raising the lower-bounds, by 
> reducing the 
> upper-bounds, and/or by reducing the alternative size 
> choices." So, extending this size may not be permitted.
> 
> Thanks,
> Azlina
> 
> Jean-Francois Mule wrote:
> > Rich,
> > 
> > Reviewing the cable device v2 mib to create the compliance
> statement
> > for PacketCable Standalone MTAs, we noticed that the object size is
> > limited to 64 chars. While this may be plenty for tftp 
> filenames, it
> > could be a bit restrictive in the case of HTTP download.
> > 
> > Therefore, we'd like to recommend the following:
> >  - the docsDevSwFilename object definition be extended to a size of
> > 128 at a minimum
> >  - the compliance statement for v2 DOCSIS CM restrict the 
> implementation to 64 for those devices so that there is no
> requirement change for DOCSIS
> > 
> > docsDevSwFilename OBJECT-TYPE
> >         SYNTAX      SnmpAdminString (SIZE (0..64))
> >         MAX-ACCESS  read-write
> >         STATUS      current
> >         DESCRIPTION
> >             "The filename of the software image to be downloaded via
> >              TFTP, or the abs_path (as defined in RFC2616) of the
> >              software image to be downloaded via HTTP.
> > 
> >              Unless set via SNMP, this is the filename or abs_path
> >              specified by the provisioning server during the boot
> >              process, that corresponds to the software version that
> >              is desired for this device.
> > 
> >              If unknown, the value of this object is the
> empty string."
> >         ::= { docsDevSoftware 2 }
> > 
> > Comments appreciated.
> > Jean-François
> > 
> >>-----Original Message-----
> >>From: [email protected] [mailto:[email protected]]
> >>Sent: Monday, October 27, 2003 3:10 PM
> >>Cc: [email protected]
> >>Subject: I-D ACTION:draft-ietf-ipcdn-device-mibv2-06.txt
> >>
> >>
> >>A New Internet-Draft is available from the on-line Internet-Drafts 
> >>directories. This draft is a work item of the IP over Cable Data 
> >>Network Working Group of the IETF.
> >>
> >>	Title		: Cable Device Management Information 
> >>Base for DOCSIS compliant Cable Modems and Cable Modem Termination 
> >>Systems
> >>	Author(s)	: R. Woundy
> >>	Filename	: draft-ietf-ipcdn-device-mibv2-06.txt
> >>	Pages		: 79
> >>	Date		: 2003-10-27
> >>	
> >>This memo is a draft revision of the standards track RFC-2669. 
> >>Please see 'Revision Descriptions' below for a description of 
> >>changes.  This document will obsolete RFC-2669 when accepted. This 
> >>memo defines a portion of the Management Information Base (MIB) for 
> >>use with network management protocols in the Internet community. In 
> >>particular, it defines a basic set of managed objects for SNMP- 
> >>based management of DOCSIS compliant Cable Modems and Cable Modem
> >>Termination Systems. This memo is a product of the IPCDN 
> >>working group within the Internet Engineering Task Force.  
> >>Comments are solicited and should be addressed to the working 
> >>group's mailing list at [email protected] and/or the author.
> >>
> >>A URL for this Internet-Draft is: 
> >>http://www.ietf.org/internet-drafts/draft-ietf-ipcdn-device-mi
> > 
> > bv2-06.txt
> > 
> > To remove yourself from the IETF Announcement list, send a
> message to
> > ietf-announce-request with the word unsubscribe in the body
> of the message.
> > 
> > Internet-Drafts are also available by anonymous FTP. Login
> with the username "anonymous" and a password of your e-mail
> address. After logging in, type "cd internet-drafts" and then
> > 	"get draft-ietf-ipcdn-device-mibv2-06.txt".
> > 
> > A list of Internet-Drafts directories can be found in
> > http://www.ietf.org/shadow.html
> > or ftp://ftp.ietf.org/ietf/1shadow-sites.txt
> > 
> > 
> > Internet-Drafts can also be obtained by e-mail.
> > 
> > Send a message to:
> > 	[email protected].
> > In the body type:
> > 	"FILE /internet-drafts/draft-ietf-ipcdn-device-mibv2-06.txt".
> > 	
> > NOTE:	The mail server at ietf.org can return the document in
> > 	MIME-encoded form by using the "mpack" utility.  To use this
> > 	feature, insert the command "ENCODING mime" before the "FILE"
> > 	command.  To decode the response(s), you will need "munpack" or
> > 	a MIME-compliant mail reader.  Different MIME-compliant
> mail readers
> > 	exhibit different behavior, especially when dealing with
> > 	"multipart" MIME messages (i.e. documents which have been split
> > 	up into multiple messages), so check your local documentation on
> > 	how to manipulate these messages.
> > 		
> > 		
> > Below is the data which will enable a MIME compliant mail reader
> > implementation to automatically retrieve the ASCII version of the 
> > Internet-Draft.
> > 
> > _______________________________________________
> > IPCDN mailing list
> > [email protected]
> > https://www1.ietf.org/mailman/listinfo/ipcdn
> > 
> 
> 
>
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.