Re: finishings-supported and finishings-default
Michael Sweet via ipp <[email protected]>
| Newsgroups | gmane.ietf.ipp |
|---|---|
| Message-ID | <[email protected]> |
Smith, > On Nov 21, 2021, at 2:32 PM, Kennedy, Smith (Wireless & IPP Standards) via ipp <[email protected]> wrote: > > Hi there, > > If a Printer lists the following (ippserver .conf file syntax): > > ATTR enum finishings-supported 4,20,21,22,23 # matches "finishing-template-supported" > ATTR enum finishings-default 3 # none > > If a Printer supports doing "no finishings" (enum 3), is the Printer required to list 3 (none) in finishings-supported? Our IPP Everywhere Self-Certification doesn't support that scenario currently but STD92 is vague on this subject. If 'none' is a supported value (and it must be if "finishings-default" uses it, just like any other xxx-default attribute), then it MUST also be listed in "finishings-supported". It is conceivable that there might be a printer that always performs some sort of finishing, for example cutting a sheet from a roll, but most of the time I'd expect a printer that supports finishings to also support 'none'. ________________________ Michael Sweet