Re: [EXTERNAL] IPP WG Last Call: IPP Envelope Media Extensions v1.0 (ENVELOPE) [Ends May 9, 2025]

@Michael Ziller, I agree.
Attached is the client job scenario, same diagram with output illustration and corrected feed-orientation is in red.
Is my understanding right?
Thanks
Charles
-----Original Message-----
From: ipp <[email protected]> On Behalf Of Michael Ziller via ipp
Sent: Friday, May 16, 2025 10:03 AM
To: ISTO-PWG Internet Printing Protocol workgroup discussion forum <[email protected]>
Cc: Michael Ziller <[email protected]>
Subject: Re: [IPP] [EXTERNAL] IPP WG Last Call: IPP Envelope Media Extensions v1.0 (ENVELOPE) [Ends May 9, 2025]

Email was not sent from a Canon Network!

Sorry for noticing this late, but can we review Figure 1 - Flap Locations?

It's easier I believe to explain if we rotated all these images with the leading edge at the top of the page. And then:
- The first image has feed-orientation=portrait, feed-direction=short-edge-edge-first, and here the flap is along the leading edge
- But the last image has feed-orientation=reverse-landscape, feed-direction=long-edge-first

Since the envelope flap is also along the leading edge here, shouldn't the feed-orientation be landscape instead of reverse-landscape?

- For the second image, since the flap location is rotated 3 counterclockwise 90 degree rotations from the leading edge, shouldn't feed-orientation be reverse-landscape rather than landscape?

Thanks,
Michael Ziller

-----Original Message-----
From: ipp <[email protected]> On Behalf Of Michael Sweet via ipp
Sent: Friday, April 25, 2025 1:30 PM
To: PWG IPP Workgroup <[email protected]>
Cc: Michael Sweet <[email protected]>
Subject: [EXTERNAL] [IPP] IPP WG Last Call: IPP Envelope Media Extensions v1.0 (ENVELOPE) [Ends May 9, 2025]

All,

This message starts the IPP workgroup last call of the IPP Envelope Media Extensions v1.0 (ENVELOPE) registration at:

    https://ftp.pwg.org/pub/pwg/ipp/wd/wd-ippenvelope10-20250425.pdf

This registration extends the definition of envelope media sizes to include flap location and orientation.

Please "reply all" to this message with any feedback or comments about the content of this registration before 10pm PT on May 9, 2025.

We plan on publishing this registration and the new attributes to the IANA IPP registry after a successful conclusion of this last call.

________________________
Michael Sweet

_______________________________________________
ipp mailing list
[email protected]
https://www.pwg.org/mailman/listinfo/ipp
_______________________________________________
ipp mailing list
[email protected]
https://www.pwg.org/mailman/listinfo/ipp

_______________________________________________
ipp mailing list
[email protected]
https://www.pwg.org/mailman/listinfo/ipp