Re: Envelope Media Extension Testing

Thanks, Mike!

-----Original Message-----
From: Michael Sweet <[email protected]>
Sent: Tuesday, August 19, 2025 12:21 PM
To: PWG IPP Workgroup <[email protected]>
Cc: Charles Armstrong <[email protected]>
Subject: Re: [IPP] Envelope Media Extension Testing

Email was not sent from a Canon Network!

Charles,

Only the media-size-supported, media-col-ready, and media-col-database attributes need the X and Y values "swapped" (x-dimension < y-dimension) for the long-edge flap envelope sizes.


> On Aug 19, 2025, at 2:20 PM, Charles Armstrong via ipp <[email protected]> wrote:
>
> Hi Mike,
> Following up on your suggestion to swap the x-dimension and y-dimension values for the envelope size (‘jpn_you4-long-flap_235x105mm’ ):
> Does this change need to be applied to all attributes where media dimensions are specified for the envelope size, or is it specific to attributes such as media-supported, media-size-supported, media-col-database, and media-col-ready?
> (begin-collection):
>     (begin-collection)
>        (integer) x-dimension: 10500
>        (integer) y-dimension: 23500
>  Thanks
> Charles
>  _______________________________________________
> ipp mailing list
> [email protected]
> https://www.pwg.org/mailman/listinfo/ipp


________________________
Michael Sweet

_______________________________________________
ipp mailing list
[email protected]
https://www.pwg.org/mailman/listinfo/ipp