Re: One DataAckSNACK for two "A"s
William Studenmund <[email protected]>
| Newsgroups | gmane.ietf.ips |
|---|---|
| Message-ID | <[email protected]> |
On Mar 27, 2006, at 6:14 PM, Eddy Quicksall wrote: > Suppose the target sends two sequences with the A bit set (both for > the same task and both are within the length constraints that apply > to the use of the A bit). Also assume DataSequenceInOrder is Yes. > > Can the initiator send just one DataAckSNACK after the 2nd sequence > with the appropriate BegRun for the 2nd sequence? What is the initiator trying to do? From reading the RFC, the initiator can in fact do this. However this would imply that there was an issue with the first sequence and that it is being re-requested. I think it would also be reasonable to have one DataAckSNACK that covered both runs, but in that case you'd start with the BegRun from the 1st sequence. Take care, Bill _______________________________________________ Ips mailing list [email protected] https://www1.ietf.org/mailman/listinfo/ips
PGP.sig
(application/pgp-signature, 186 B) - not displayed