Re: iSER use of ITT in Data_Completion_Notify

That is true but it would be better if the TTT were supplied for the target 
to identify the structure used for the data. That way the target does not 
need to catalog the ITT. The TTT could just be an index or a pointer that 
can be resolved quite easily.


Eddy

----- Original Message ----- 
From: "Mike Ko" <[email protected]>
To: "Eddy Quicksall" <[email protected]>
Cc: <[email protected]>
Sent: Tuesday, September 05, 2006 7:44 PM
Subject: Re: [Ips] iSER use of ITT in Data_Completion_Notify


> ITT is used to identify a task during its execution by both the initiator
> and the target.  See RFC3720.  It is for this reason that it is used as an
> input qualifier in Data_Completion_Notify.
>
> Mike
>
>
>
>             "Eddy Quicksall"
>             <eddy_quicksall_i
>             Vivity_iSCSI@Comc                                          To
>             ast.net>                  <[email protected]>
>                                                                        cc
>             09/05/2006 03:49
>             PM                                                    Subject
>                                       [Ips] iSER use of ITT in
>                                       Data_Completion_Notify
>
>
>
>
>
>
>
>
>
>
> Data_Completion_Notify is used at the target to notify the completion of
> Data-in or Data-out. The ITT is given as one of the Input Qualifiers. But
> the ITT is not understood by the target. It would seem that the TTT is 
> what
> should be given instead since that is understood by the target.
>
> What am I missing?
>
> Eddy_______________________________________________
> Ips mailing list
> [email protected]
> https://www1.ietf.org/mailman/listinfo/ips
>
>
>
> _______________________________________________
> Ips mailing list
> [email protected]
> https://www1.ietf.org/mailman/listinfo/ips
> 


_______________________________________________
Ips mailing list
[email protected]
https://www1.ietf.org/mailman/listinfo/ips