Re: Response Fence Flag
"Eddy Quicksall" <[email protected]>
| Newsgroups | gmane.ietf.ips |
|---|---|
| Message-ID | <[email protected]> |
How do I get that? T10.org references it as "missing":
06-341r1
SAM-4 Response Fence for protocol services
Rob Elliott
Missing
----- Original Message -----
From: Elliott, Robert (Server Storage)
To: [email protected]
Sent: Wednesday, January 03, 2007 4:55 PM
Subject: RE: [Ips] Response Fence Flag
If T10 agrees, T10 proposal 06-341 will add it to SAM-4.
--
Rob Elliott, [email protected]
Hewlett-Packard Industry Standard Server Storage Advanced Technology
https://ecardfile.com/id/RobElliott
----------------------------------------------------------------------------
From: Eddy Quicksall [mailto:[email protected]]
Sent: Wednesday, January 03, 2007 2:00 PM
To: [email protected]
Subject: [Ips] Response Fence Flag
Section 3.3.1 talks about a Response Fence Flag:
SCSI protocol layer instructs the SCSI transport layer of a
"Response Fence" associated with the response in question when
the "Send Command Complete" protocol data service (SAM-2, clause
5.4.2) ...
But I don't see any reference to that in SAM-2.
Is this strictly an iSCSI flag? Where is the flag specified?
Eddy
------------------------------------------------------------------------------
_______________________________________________
Ips mailing list
[email protected]
https://www1.ietf.org/mailman/listinfo/ips
_______________________________________________
Ips mailing list
[email protected]
https://www1.ietf.org/mailman/listinfo/ips