RE: Device Identification VPD Page for iSCSI Targets

The PROTOCOL_IDENTIFIER should be 5h if the identifier in the descriptor
is an iSCSI protocol specific identifier.

Thanks,
 
Jacob Cherian
Dell Inc.
Ph: (512) 723 3247


-----Original Message-----
From: Eddy Quicksall [mailto:[email protected]] 
Sent: Monday, January 08, 2007 10:05 AM
To: RAM SUNEE; [email protected]
Subject: Re: [Ips] Device Identification VPD Page for iSCSI Targets

Referring to Table 296 of spc4r07a it seems the value should be 5
meaning 
iSCSI.

Eddy

----- Original Message ----- 
From: "RAM SUNEE" <[email protected]>
To: <[email protected]>
Sent: Monday, January 08, 2007 10:20 AM
Subject: [Ips] Device Identification VPD Page for iSCSI Targets


> All,
>
> Can anyone please clarify me regarding, Device Identification VPD
usage 
> for
> iSCSI Target.
> What values should an iSCSI Target use for PROTOCOL_IDENTIFIER, 
> ASSOCIATION
> fields of Device Identification VPD response page.
> I have noticed that iSCSI Targets are reportng to Initiators as "SCSI
Disk
> Device",is it correct behavior?
> Isn't it supposed to be that iSCSI Target needs to report to Initiator
as
> "iSCSI Disk Device"
>
> -RAM
>
>
>
> _______________________________________________
> Ips mailing list
> [email protected]
> https://www1.ietf.org/mailman/listinfo/ips
> 


_______________________________________________
Ips mailing list
[email protected]
https://www1.ietf.org/mailman/listinfo/ips

_______________________________________________
Ips mailing list
[email protected]
https://www1.ietf.org/mailman/listinfo/ips