Re: time-out for R2T PDUs?
"Erez Zilber" <[email protected]> Thu, 6 Nov 2008 17:53:12 +0200
| Newsgroups | gmane.ietf.ips |
|---|---|
| Message-ID | <[email protected]> |
Got it. Thanks. Erez On Thu, Nov 6, 2008 at 5:31 PM, Julian Satran <[email protected]> wrote: > The target may try to finish the command with a "check condition" or some > connection recovery before resorting to the big hammer. > > Julo > > > From: > "Erez Zilber" <[email protected]> > To: Julian Satran/Haifa/IBM@IBMIL > Cc: "Deva Ranganathan" <[email protected]>, [email protected] > Date: 06/11/2008 10:15 > Subject: Re: [Ips] time-out for R2T PDUs? > ________________________________ > > > There could be a situation in which NOP-IN PDUs from the target are > sent successfully to the initiator, but some bug causes the initiator > not to send the data-out PDU. According to what you say, the target > may decide that it can't wait anymore and logout, right? > > Thanks, > Erez > > On Thu, Nov 6, 2008 at 3:09 PM, Julian Satran <[email protected]> > wrote: >> Correct - there is no standard time-out. Regards, Julo >> >> >> From: "Deva Ranganathan" <[email protected]> >> To: "Erez Zilber" <[email protected]> >> Cc: [email protected] >> Date: 06/11/2008 04:20 >> Subject: Re: [Ips] timeout for R2T PDUs? >> ________________________________ >> >> >> >> >> On Thu, Nov 6, 2008 at 2:46 PM, Deva Ranganathan >> <[email protected]> wrote: >> Erez, >> >> I think that this s a target implementation issue wherein the >> implementation >> can choose the timeout depending on the availability of resources and >> the >> software architecture. A target also has a NOP-IN sent periodically and >> can >> use this to cleanup the stale resources as well. >> >> thanks >> >> Deva >> HCL Technologies. >> >> >> >> On Thu, Nov 6, 2008 at 12:54 PM, Erez Zilber <[email protected]> >> wrote: >> Hi, >> >> I couldn't find an answer to the following question in iSCSI spec: >> >> During the execution of a WRITE command, an R2T PDU is sent from the >> target to the initiator. What should happen if a bug in the initiator >> causes it not to send the data-out PDU? Is there any timeout that will >> allow the target to abort this command? >> >> Thanks, >> Erez >> _______________________________________________ >> Ips mailing list >> [email protected] >> https://www.ietf.org/mailman/listinfo/ips >> >> _______________________________________________ >> Ips mailing list >> [email protected] >> https://www.ietf.org/mailman/listinfo/ips >> >> >> > > > _______________________________________________ Ips mailing list [email protected] https://www.ietf.org/mailman/listinfo/ips