TDMoPW: HDLC-mode and Q.931

Javi <[email protected]>
Newsgroups gmane.ietf.l2tpext
Message-ID <[email protected]> 
A question about TDMoIP documents RFC4197 and 
draft-ietf-pwe3-tdm-control-protocol-extensi,

Both ones mentions TDMoIP may be used to transport ISDN PRI signaling by 
HDLC-mode. But, does this mean that?

- TDMoIP develops over PSN Q.931, Q.921 or I.431 over PSN ¿?. The main 
difference between BRI and PRI is at L1. Also, if L2TPv3/IP is used, 
RFC3931 suggests its use to emulate L2 services.

- TDMoIP is suitable to transport an ISDN aggregate of B-channels (2 
B-channels at BRI or n B-channels at PRI)

- TDMoIP is able to guarantee delay and jitter requirements for ISDN 
structures RDTD and TSSI

Thanks,

Javier Muñoz
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.