[Models] equality matching rule properties.
"Kurt D. Zeilenga" <[email protected]>
| Newsgroups | gmane.ietf.ldapbis |
|---|---|
| Message-ID | <[email protected]> |
I suggest adding the following statement to section 2.5.1 of [Models] (at end of paragraph starting with "Otherwise, ..."). The specified equality rule is to be transitive and commutative. -- Kurt At 12:27 PM 2/15/2005, Kurt D. Zeilenga wrote: >It is hoped that this revision adequately addresses comments >received during IESG review. In particular, the following change >was made to clarify the relationship to ITU recommendations and >the applicability of LDAP-specific adaptations: > > This document includes material, with and without adaptation, from >-[X.501]. The material in this document takes precedence over that >-in [X.501]. >+[X.501] as necessary to describe this protocol. These adaptations >+(and any other differences herein) apply to this protocol, and only >+this protocol. > >I see a few minor issues need to be resolved prior to further >IESG consideration. > 1) incorporation of 'supportedFeatures' [RFC3674], > 2) addition of statement regarding properties (commutative, etc.) > which equality matching rules should have, > 3) addition of statement that each value must be equal > (or equivalent) to itself to be included in a set of > attribute values, and > 4) clarifications of matchingRuleUse 'APPLIES'. > >I intend to offer specific text in 1-3 later today, and will >work with Jim on 4. > >Kurt > > >At 07:33 AM 2/15/2005, [email protected] wrote: >>A New Internet-Draft is available from the on-line Internet-Drafts directories. >>This draft is a work item of the LDAP (v3) Revision Working Group of the IETF. >> >> Title : LDAP: Directory Information Models >> Author(s) : K. Zeilenga >> Filename : draft-ietf-ldapbis-models-13.txt >> Pages : 51 >> Date : 2005-2-14 >> >>The Lightweight Directory Access Protocol (LDAP) is an Internet >> protocol for accessing distributed directory services which act in >> accordance with X.500 data and service models. This document >> describes the X.500 Directory Information Models, as used in LDAP. >> >>A URL for this Internet-Draft is: >>http://www.ietf.org/internet-drafts/draft-ietf-ldapbis-models-13.txt >> >>To remove yourself from the I-D Announcement list, send a message to >>[email protected] with the word unsubscribe in the body of the message. >>You can also visit https://www1.ietf.org/mailman/listinfo/I-D-announce >>to change your subscription settings. >> >> >>Internet-Drafts are also available by anonymous FTP. Login with the username >>"anonymous" and a password of your e-mail address. After logging in, >>type "cd internet-drafts" and then >> "get draft-ietf-ldapbis-models-13.txt". >> >>A list of Internet-Drafts directories can be found in >>http://www.ietf.org/shadow.html >>or ftp://ftp.ietf.org/ietf/1shadow-sites.txt >> >> >>Internet-Drafts can also be obtained by e-mail. >> >>Send a message to: >> [email protected]. >>In the body type: >> "FILE /internet-drafts/draft-ietf-ldapbis-models-13.txt". >> >>NOTE: The mail server at ietf.org can return the document in >> MIME-encoded form by using the "mpack" utility. To use this >> feature, insert the command "ENCODING mime" before the "FILE" >> command. To decode the response(s), you will need "munpack" or >> a MIME-compliant mail reader. Different MIME-compliant mail readers >> exhibit different behavior, especially when dealing with >> "multipart" MIME messages (i.e. documents which have been split >> up into multiple messages), so check your local documentation on >> how to manipulate these messages. >> >> >>Below is the data which will enable a MIME compliant mail reader >>implementation to automatically retrieve the ASCII version of the >>Internet-Draft. >>Content-Type: text/plain >>Content-ID: <[email protected]> >> >>ENCODING mime >>FILE /internet-drafts/draft-ietf-ldapbis-models-13.txt >> >><ftp://ftp.ietf.org/internet-drafts/draft-ietf-ldapbis-models-13.txt>