Re: IGMP NonQuerier Adopted Robustness value

Thanks a lot to Bharat and Kunal for replies.

~RajaSekhar

On Mon, Nov 30, 2009 at 12:25 PM, Kunal Shah <[email protected]>wrote:

>  Hi,
>
>    IMO, start-up query count is used when IGMP has just come up on an
> interface and is not aware of who the querier is and hence, what values to
> use for robustness. So start-up query count should not be changed even when
> the querier's robust values are adopted.
>
> Kunal
>
>  ------------------------------
> *From:* [email protected] [mailto:[email protected]] *On Behalf
> Of *rajasekar bonthala
> *Sent:* Sunday, November 29, 2009 10:28 PM
>
> *To:* [email protected]; [email protected]
> *Subject:* [magma] IGMP NonQuerier Adopted Robustness value
>
>   Hi,
>
> In the IGMP RFC it is mentioned that Non-Querier adopts the Robustness
> value of the querier.
> There are some IGMP Protocol parameters, where they depend on Robustness to
> derive their value, for example non-querier timeout, start-up query
> count etc... I think these should also change accordingly, after adopting
> robustness.
>
> In the case of start-up query count,  is it required that start-up query
> count should also change ?
>
> Thanks,
> RajaSekhar
>
>

_______________________________________________
magma mailing list
[email protected]
https://www.ietf.org/mailman/listinfo/magma