Megaco digitmap timer

Ramesh Babu Kuppili <[email protected]> Fri, 28 Dec 2007 12:08:00 +0530

Newsgroups	gmane.ietf.megaco
Message-ID	<[email protected]>

Hi,
 
I have a question about megaco digitmap timer.
 
What is the scope of a timer (L or S) within a range in a megaco digitmap.  For example:
 
In the digitmap:
    15xSxxx[Lx]xxxx
 
My inference from the rfc is (taking a dial sequence of 15105551212
    Digit dialled            Timer started
        1                            L
        5                            L
        1                            L
        0                            S
        5                            S
        5                            S
        5                            L      (this is within the braces.  my assumption is that the timer specifier within braces is valid only within braces)
        1                            S
        2                            S
        1                            S
        2                            S
 
Is my inference correct that timer specifier within a brace is valid only within the brace.
 
- ramesh

_______________________________________________
Megaco mailing list
[email protected]
https://www1.ietf.org/mailman/listinfo/megaco