Re: Emergency/Priority indicators

Hello Miri,

Please see my replies below [CNG].

Regards, Christian

Miri Epstein wrote:
> Hi,
>
> I have some questions regarding the emergency and priority context
> attributes:
>
> 1/ Assuming, for example, that a context was created by an Add command
> with priority=5. Then a Modify command is issued by MGC with priority=7.
> Does this mean that the context priority is changed to 7?
>   
[CNG] Yes the priority would be 7.
> 2/ Assuming, for example, that a context was created by an Add command
> with the emergency indicator (emergency is ON). A consequent Modify
> command omitting the emergency indicator is issued by the MGC. Does it
> mean that this specific context is not anymore an emergency context?
>   
[CNG] If a Context property is omitted then it retains the previous 
setting. So it would remain on.
> 3/ Are these scenarios of modifying the context attributes reasonable?
> Or, is it expected that a specific priority level set to a context will
> not be changed until the context ceases?
>   
[CNG] I would imagine that in most cases the priority would not be 
changed once the call/connection is established.
>     
> Thanks for your help,
> Miri
>
>  
> _______________________________________________
> Megaco mailing list
> [email protected]
> http://www.ietf.org/mailman/listinfo/megaco
>
>
>