Move command

Hi All,
 
I have query regarding using MOVE command alongwith other commands in
same Megaco Action.
Example : 
                  there are 2 contexts( cntx1 and cntx2 )  on gateway
for termination Term1, SCN termination is in cntx2
now I want to move SCN termination to cntx1 and apply mode=<sendreceive>
on rtp termination of cntx1
 
Is following command valid..?
 
T=12{
 C=cntx1{
  MF=rtp/1{M{O{MO=SR}}},
  MV=Term1,
  }
 }

or Do I need to send these commands in separate actions. 
 
please suggest on this..
 
 
Regards,
Rahul Ruikar
Alcatel-Lucent
Email: [email protected]
Alcanet: 2721 4732

_______________________________________________
Megaco mailing list
[email protected]
https://www.ietf.org/mailman/listinfo/megaco