Re: Isup Megaco Corellation

Hello Odelia,

There is no direct reference to a cic in Megaco. The MGC is expected to 
maintain a mapping between a cic and a TerminationID. So if the MGC 
receives an IAM it will request a particular terminationID based on the 
cic via a ADD.request.

Regards, Christian

Odelia Jacobowitz wrote:
>
> Hi ,
>
> I need to correlate between Isup to Megaco signaling messages ,
>
> Can I expect to find in the ADD request (Megaco message) reference to 
> the cic from the Iam (Isup message) ?
>
> * In the MGCP protocol for instance the cic was encapsulated in the 
> endpoint EI .
>
> *Please advice …*
>
> *Regards,*
>
> *Odelia Jacobowitz*
>
> Embedded Software Engineer
>
> * *
>
> Septier Communications Ltd.
>
> *Tel :* +972-(0) 3-924-7026 (123)
>
> *Fax:* +972-(0) 9-924-7023
>
> *Cell:* +972-(0)54-4790-668
>
> Email: [email protected] <mailto:[email protected]>_
>
> Web: www.septier.com <BLOCKED::http://www.septier.com>
>
> ------------------------------------------------------------------------
>
> _______________________________________________
> Megaco mailing list
> [email protected]
> https://www.ietf.org/mailman/listinfo/megaco
>