sendRecv and busy tone on physical termination in the same time

"Maxim Treskin" <[email protected]>
Newsgroups gmane.ietf.megaco
Message-ID <[email protected]> 
Hello

Is it normal, when MGC sends me signal cg/bt and termination mode
send/receive in the same packet?
Which behaviour must be realised on this termination: switch TDM port
of termination to RTP or signal to it busy?

Thank you
-- 
Maxim Treskin
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.