Re: Subtract all calls

Hello,
This is an optional wildcarded subtract command and MGC is not interested in knowing the termination ids in response.
If there are contexts present then MG should return
!/1 [10.100.4.28]:2944 T=95{C=*{S=*}}


Else it should return with error descriptor
!/1 [10.100.4.28]:2944 T=95{ER=411{}}

Please refer to mail with subject "cleaning up of contexts" dated 31/05/2002

With regards,
Deepak Bissa
Extn 5106
________________________________
From: [email protected] [mailto:[email protected]] On Behalf Of Tamar Nemet
Sent: Monday, September 22, 2008 4:35 PM
To: [email protected]
Subject: [Megaco] Subtract all calls

Hi,

When MG get the following message for MGC:

!/1 [10.100.4.28]:2944 T=95{C=*{O-W-S=*{AT{}}}}

What it should do ? I understand that it should subtract all calls, but what it should put in the reply ? all the termination that had been subtracted ? And if it has 2000 calls , how it can be sent in one reply ?

Thanks for your help,
Tamar

________________________________
"DISCLAIMER: This message is proprietary to Aricent and is intended solely for the use of the individual to whom it is addressed. It may contain privileged or confidential information and should not be circulated or used for any purpose other than for what it is intended. If you have received this message in error,please notify the originator immediately. If you are not the intended recipient, you are notified that you are strictly prohibited from using, copying, altering, or disclosing the contents of this message. Aricent accepts no responsibility for loss or damage arising from the use of the information transmitted by this email including damage from virus."

_______________________________________________
Megaco mailing list
[email protected]
https://www.ietf.org/mailman/listinfo/megaco