Re: SDP question

Tamar,

which H.248 profile do you use?

 

If you use an H.248 Border Gateway profile, then it might be the "-"
character.

See ETSI ES 283 018.

[You may also see the discussion on RFC 2327 vs 4566, because the "-"
was not yet part of the RFC 2327 grammar.]

 

However, I would rather suppose an error in the descriptor (due to the
media format list, which implies a transport protocol (stack), which
might be RTP profile "AVP" here ...

 

 

________________________________

From: [email protected] [mailto:[email protected]] On Behalf
Of Tamar Nemet
Sent: Sonntag, 14. Dezember 2008 11:24
To: [email protected]
Subject: [Megaco] SDP question

 

Hi,

 

The remote SDP we get in the Megaco ADD command includes the following
line:

 

m=audio 50006 NoToken 0 8 18 110 111

 

What is the meaning of NoToken here ? I usually get RTP/AVP here and
didn't find any explanation in the SDP standard.

 

Can anybody help ?

 

Thanks,

Tamar

_______________________________________________
Megaco mailing list
[email protected]
https://www.ietf.org/mailman/listinfo/megaco