Re: About fax control mode

Hi Deepak,

 

Yes, I got the answer at the Annex E2.2.

Thanks a lot,

 

Regards,

Gary

 

  _____  

From: Deepak Bissa [mailto:[email protected]] 
Sent: Wednesday, August 26, 2009 11:36 AM
To: Gary Li; [email protected]
Subject: RE: [Megaco] About fax control mode

 

Hi Gary,

ITU-T Rec. T.38 (Appendix III) describes the softswitch control and MG
Autonomous switchover to fax.

Packages used in softswitch control fax e.g. ctyp, fax and ipfax are
published in ITU-T Rec. H.248.2.

 

With regards,

Deepak Bissa

  _____  

From: [email protected] [mailto:[email protected]] On Behalf Of
Gary Li
Sent: Wednesday, August 26, 2009 7:23 AM
To: [email protected]
Subject: [Megaco] About fax control mode

 

Hi,

 

About fax mode, there are four control mode.

1.       non-control 

2.       RTCP control 

3.       softswitch control

4.       Auto VBD(gateway self-negociate)

 

Can any one help me clarify the means of above fax mode?

And what the MGC behaviour when choose the mode?

 

PS: I can't find it at any IETF or ITU document. If anyone knows, pls tell
me.

Any information will be appreciated!

Thanks

 

Regards,

Gary

 

  _____  

"DISCLAIMER: This message is proprietary to Aricent and is intended solely
for the use of the individual to whom it is addressed. It may contain
privileged or confidential information and should not be circulated or used
for any purpose other than for what it is intended. If you have received
this message in error,please notify the originator immediately. If you are
not the intended recipient, you are notified that you are strictly
prohibited from using, copying, altering, or disclosing the contents of this
message. Aricent accepts no responsibility for loss or damage arising from
the use of the information transmitted by this email including damage from
virus."

_______________________________________________
Megaco mailing list
[email protected]
https://www.ietf.org/mailman/listinfo/megaco