Re: Regarding audio record

Hi.

I was the editor of that package years ago.

A Signals Descriptor applies to a specific termination. That means you
can select which party is to be recorded. If you look at the definition of the 
PlayRecord signal, it says it records the incoming stream from the user. So that 
is all there is to it.

Tom Taylor

shalu dhamija wrote:
> 
> Hi All,
> 
...

> I have a query on advanced audio server recording (aasrec) package.
> According to 3GPP 23.333, the functional requirements for the audio record
> states that:
> 
...
> 
> “The MRFC shall request the MRFP to start the audio record from one or all
> parties connected in a call/session. If it is to record one party in a
> call/session, only the input stream of the party is recorded. If it is to
> record all parties in a Call/session, the mixed stream of all parties is
> recorded. “
...
> 
> I am unable to understand that how to specify the input stream of the party
> in a Megaco message.   Can anybody illustrate how MRFC tells MRFP about the
> input stream to be recorded? I have not got any parameter in the aasrec
> package. In this package, the mandatory parameter in the signals descriptor
> is the recording identifier (rid) which I think is just the URI (where the
> recording is to be stored).
> 
...>
> Thanks and Regards,
> 
> 
> 
> Shalu
> 
...
_______________________________________________
Megaco mailing list
[email protected]
https://www.ietf.org/mailman/listinfo/megaco