MEGACO/H248 Statistic/QoS

Hi,

                                                                        

I am checking the Statistics and Quality of Service  of the H248 signaling in the NGN Network, using probes. 

 

I have two cases of study:

 

1.       Termination Statistics of media context. (SUBTRACT). Including Packets IN/OUT, Packet loss, jitter, delay.

2.       Release/End causes H248 of the calls.

 

So, In the case 2, I need your help. What is the mapping of the Release/End Causes for H248 (like ISUP ITU-T  q.850) or What is the best practice to check the user behavior or problems in the H248.  Now, I am seeing end causes like: MEGACO: 433 TerminationID is already in a Context, or MEGACO: 500 Internal Gateway Error, MEGACO: Timeout, etc.

 

                Possible Calls flow:

 

a.       ACCESS MEDIA GW 1 ßH248à SOFTSWITCH ß H248 àACCESS MEDIA GW 2. (Only the ACCESS MEDIA GW 1 sends the B number in the H248 signaling).

 

b.      b.1. PSTN ßISUPà SIGNALING GW ß SIGTRAM à SOFTSWITCH.

b.2. PSTN (VOICE E1) ßàTRUNK MEDIA GW ßH248à SOFTSWITCH ß H248 àTRUNK MEDIA GW OR ACCESS MEDIA GW. (A and B number are in ISUP/SIGTRAM signaling). 

 

c.       Central Office (not NGN)ßR2à TRUNK MEDIA GW ßH248à SOFTSWITCH ß H248 à TRUNK MEDIA GW OR ACCESS MEDIA GW. (A and B number are in H248 signaling)

    

d.      d.1. Central  Office (not NGN) ßISUPà SIGNALING GW ßSIGTRAMà SOFTSWITCH. 

d.2. Central Office (not NGN)ßVOICE E1à TRUNK MEDIA GW ßH248à SOFTSWITCH ß H248 à TRUNK MEDIA GW OR ACCESS MEDIA GW. (A and B number are in ISUP/SIGTRAM signaling). 

 

Thanks in advanced,

 

Eugenio Flores

CANTV

_______________________________________________
Megaco mailing list
[email protected]
https://www.ietf.org/mailman/listinfo/megaco