Re: Port Blocking in Firewall
Tom Taylor <[email protected]> Mon, 06 Dec 2004 05:33:24 -0500
| Newsgroups | gmane.ietf.midcom |
|---|---|
| Message-ID | <[email protected]> |
That's right. Basically the attitude was that administration would block everything by default, and MIDCOM would enable exceptions (subject to policy at the server). Pyda Srisuresh wrote: > My understanding is that the WG decided to go with specifyign just the > permitted ports, not the blocked ports, during the semantics discussion. > > regards, > suresh > --- Tom Green <[email protected]> wrote: > > >>Hi, >> >>I am kind of new to MidCom. RFC 3303(MidCom >>Architecture and Framework)says that MidCom protocol >>will enable us to open select ports in the firewall. >>Is it possible to block some ports using this >>framework? >> >>Thanks, >>TG >> >> >> >>__________________________________ >>Do you Yahoo!? >>Take Yahoo! Mail with you! Get it on your mobile phone. >>http://mobile.yahoo.com/maildemo >> >>_______________________________________________ >>midcom mailing list >>[email protected] >>https://www1.ietf.org/mailman/listinfo/midcom >> > > > > ===== > > > _______________________________________________ > midcom mailing list > [email protected] > https://www1.ietf.org/mailman/listinfo/midcom > > -- Tom Taylor Carrier VoIP Standards Development Nortel Networks Phone +1 613 763 1496 (ESN 393-1496) E-mail: [email protected]