[email protected] wrote:
>
> Err, I'm a bit confused today... I cannot find anything in 2401bis
> that would actually use the (outer) address in _inbound_ IPsec SAs
> for anything when processing unicast traffic.
>
> => the destination address of packets sent over an IPsec tunnel SA
> is a mandatory parameter on the sending side, in this case the
> other peer.
Ok, now I understand where the confusion came from: we had
a small mismatch in terminology (2401bis calls those SAs
"outbound" :-)
Best regards,
Pasi
lmpx.com only provides a reader for public news (NNTP) servers. It is not
affiliated with the servers or forums shown here and is not responsible for
the content of articles, which is written by their respective authors.