RE: issue 10: changing addresses or paths?

hi jari, 

i agree with you that we need to test paths rather than addresses. i have
read your multi6 draft
<http://www.ietf.org/internet-drafts/draft-arkko-multi6dt-failure-detection-
00.txt> which also derives this conclusion. 

my personal experience with path-coupled signaling in the nsis environment
also supports this observation.

ciao
hannes

> Our earlier resolution of issue 17 (if both parties have 
> several addresses, do we assume that all pairs have 
> connectivity between them?) was that we should NOT assume 
> full connectivity in these cases.
> 
> I believe the above resolution implies that upon a problem, 
> we may have to switch paths, not just an address. I also 
> explained the issue in Washington in my presentation.
> 
> So I think its pretty clear that the answer to this question 
> is that we need to be able to change paths.
> Suggested text below:
> 
> Change design draft from
> 
> 6.  Changing addresses or changing the paths (issue #10, #14)
> 
>     The question here is, if it is enough for the MOBIKE to detect the
>     dead-address, or do it need to detect also dead-paths. 
> Dead-address
>     detection means that we only detect that we cannot get packets
>     through to that remote address by using the local 
> IP-address given by
>     the local IP-stack (i.e. local address selected normally by the
>     routing information). Dead-path detection means that we 
> need to try
>     all possible local interfaces/IP-addresses for each 
> remote addresses,
>     i.e. find all possible paths between the hosts and try them all to
>     see which of them work (or at least find one working path).
> 
>     Doing the dead-address detection is simpler, and there is 
> less probe
>     packets to be sent, thus it does not cause that much stress to the
>     network. It also is enough for the scenarios where the connection
>     problems are local (i.e. interfaces going down, WLAN access
>     disappearing etc). It does not help if some router somewhere along
>     the path breaks down, in which case rerouting the packets along
>     another path might get around that broken router. The question is,
>     whether rerouting around that problem inside the core network is a
>     problem that MOBIKE needs to solve.
> 
> to
> 
> 6. Changing addresses or changing the paths (issue #10, #14)
> 
>     The question here is, if it is enough for the MOBIKE to detect the
>     dead-address, or do it need to detect also dead-paths. 
> Dead-address
>     detection means that we only detect that we cannot get packets
>     through to that remote address by using the local 
> IP-address given by
>     the local IP-stack (i.e. local address selected normally by the
>     routing information). Dead-path detection means that we 
> need to try
>     all possible local interfaces/IP-addresses for each 
> remote addresses,
>     i.e. find all possible paths between the hosts and try them all to
>     see which of them work (or at least find one working path).
> 
>     While performing just an address change is simpler, the existence
>     of locally operational addresses are not, however, a guarantee
>     that communications can be established with the peer.  A
>     failure in the routing infrastructure can prevent the sent packets
>     from reaching their destination. Or a failure of an interface on
>     one side can be related to the failure of an interface on the
>     other side, making it necessary to change more than one address
>     at a time.
> 
> --Jari
> 
> _______________________________________________
> Mobike mailing list
> [email protected]
> https://www.machshav.com/mailman/listinfo.cgi/mobike
>