Re: Issue: Support for IPv4 - IPv6 movements (#13)
Francis Dupont <[email protected]>
| Newsgroups | gmane.ietf.mobike |
|---|---|
| Message-ID | <[email protected]> |
In your previous mail you wrote: Does switching from IPv4 to IPv6 or vice versa work? (Presumably yes. Its hard to see why this would cause any problems.) => you can spread a bit the question: when an implementation supports many addresses for the same IPsec SA (cf RFC 3554, end of section 2), can the addresses mix IPv4 and IPv6? Regards [email protected] PS: IMHO the many simultaneous addresses per IPsec SA is not a good idea (not necessary and a bit hairy to implement) but when it is supported it should work with both IP versions at the same time.