Re: Issue: Support for IPv4 - IPv6 movements (#13)

Francis Dupont <[email protected]> Tue, 22 Jun 2004 19:13:27 +0200

Newsgroups	gmane.ietf.mobike
Message-ID	<[email protected]>

 In your previous mail you wrote:

   > => you can spread a bit the question: when an implementation supports
   > many addresses for the same IPsec SA (cf RFC 3554, end of section 2),
   > can the addresses mix IPv4 and IPv6?

   The IKEv2 spec clearly allows this i.e mixing IPv4 and IPv6 traffic
  selectors on a single SA.  But these are inner addresses. I thought
  Jari's question is about outer addresses ? Jari, can you clarify ?

=> I've put the reference to avoid this issue: the question is about
the outer addresses.

Regards

[email protected]