Shinta Sugimoto writes:
>
> Hello,
>
> I read draft-ietf-mobike-protocol-01.txt and had following
> comments/questions.
>
> Technical Comments/Questions:
>
> - Section 2.3 (Changing addresses in IPsec SAs) I need
> clarification on how address change functions in MOBIKE. First
> of all, does UPDATE_SA_ADDRESSES take effect on more than one
> address changes ? Or it's supposed to update a single address?
It updates the one source and one destination address in
IKE and IPsec SAs (the src/dst addresss that is currently
used for outgoing packets).
> Probably I am confusing the purpose of UPDATE_SA_ADDRESSES
> and ADDITIONAL_*_ADDRESS. In my understanding,
> UPDATE_SA_ADDRESSES is for updating the preferred address,
> which means that IKE_SA and IPsec SA (only matched one) are
> the target of the address update. OTOH, ADDITIONAL_*_ADDRESS
> is for updating (requesting its peer to update) the peer
> address set. Do I get it right?
Yes, I think you got it right (although the protocol document
does not currently use the term "peer address set"). This set is
used as input for address pair selection (on initiator side),
and possibly when responder address changes (although the
details need some clarification here...)
> One more question: Should the initiator make all the CHILD_SAs
> inactive which are associated with the IKE_SA whose "pending_update"
> flag is set ?
Why should it? (Continuing using those CHILD_SAs should work
just fine, since in 2401bis the responder uses only the SPI for
locating the inbound IPsec SA.)
Best regards,
Pasi
lmpx.com only provides a reader for public news (NNTP) servers. It is not
affiliated with the servers or forums shown here and is not responsible for
the content of articles, which is written by their respective authors.