Re: [MEXT] LISP as a solution for some part of the DMM requirement
Sri Gundavelli <[email protected]>
| Newsgroups | gmane.ietf.nemo |
|---|---|
| Message-ID | <CA5CBB8E.23279%[email protected]> |
With respect to the solutions, there are multiple approaches that are on the table. To me, to achieve a flat distributed model, we need: - the ability to select a mobility anchor closer to the access network where the mobile node is attached. 3GPP Rel-10 has done quite a few enhancements on the aspects of gateway selection. Using the parameters eNB, APN, RNC-ID, BSC-ID, ...etc - the ability to re-anchor a session, or create a new session on a new anchor closer to the new attachment point - the ability to allow the mobile node to identify the assigned IP address properties, distinguish between an address assigned in the previous access network, from an address assigned in the current access network, so it can continue to use the new address for new sessions and phase out the older address/mobility session on the previous anchor over a period of time. In other words, enhancing the SAS rules with mobility awareness will give the needed session re-anchoring capabilities This approach gives me the gateway selection closer to the access network where the mobile node is attached and the needed optimized routing path. So, I'm trying to understand what are the expectation from the DMM efforts, beyond this. Sri On 8/1/11 8:13 PM, "Sri Gundavelli" <[email protected]> wrote: > Hi Charlie, > > I agree, we have to look at other approaches and bring any value added > features to MIPv6/PMIPv6 protocols that its missing today. But, I've to say, > I'm still trying to understand the DMM problem statement and what DMM should > translate to: > > - Is it about optimized routing path ? This is very subjective and the > requirement may vary based on the use-case. Very much depends on the placement > of the anchor point. No solution on the table can ever solve this, unless we > assume the target site where the CN is located, or the ISP above is providing > some new location functions. This new location function, sure, can be a proxy > home agent at the global internet level too, for the argument sake, providing > direct path to the access network where the MN is currently attached. We also > have talked some time back on the Global HAHA, as an approach of session > re-anchoring. > > - Is it about moving from a centralized one box model to more distributed > zillion box model ? This sounds very promising on the paper. But, as we > discussed during the DMM BOF, rolling out a zillion pizza box type box anchors > sounds very cool. Sure, but we bring back ten-fold complexity in the form of > building distributed charging, Legal Intercept, DPI, Inline services, > hotlining, high-availability ...etc etc, which are now part of that one > central anchor box. It is to be noted, we have not seen a true distributed > service deployed in the internet today, other than DNS. But, I agree, if this > about building a true internet, who the heck cares about all of these > functions, in the true spirit. > > Either way, I assumed any of the new solution will be bound by the following > parameters: > > - The signaling protocol will continue to be based on MIPv6/PMIPv6 signaling > semantics. > > - We will not introduce a new client, what is now MIP client struggling to > make it to every variants of operating systems. > > - Any client-based solution will be an extension on top of DSMIP. Any > network-based solution will be an extension to PMIPv6 > > > > I hope we can discuss the solution approaches in the next meeting and bring > new extension to MIPv6/PMIPv6 protocols. > > > > > Regards > Sri > > > > > > > > > > > > > > > > > > > > > > > > > > > On 8/1/11 4:50 PM, "Seok-Joo Koh" <[email protected]> wrote: > >> Dear Charles, >> >> I think the LISP can also be considered as a promising candidate >> in the design of DMM solutions. Several works are being progressed >> to use or extend the LISP for mobility support, which inlcude LISP-MN draft >> and many research papers. Actually, I am also considering how to extend >> the LISP scheme in the DMM perspective. >> >> LISP is a network-based ID-LOC separation scheme and thus it may give some >> advantages for effective mobility support. On the other hand, it is noted >> that >> the current version of LISP and LISP-MN may need to be more enhanced >> in terms of scalability in the mobile environment. For example, one concern >> of >> LISP >> is that the LISP EIDs may not be aggregated anymore in the mobile networks, >> since >> each mobile node will have its own distinctive EIDs that do not conform the >> concerned mobile domain. >> This may decrease the scaling benefits of original LISP. >> We may need to design a new enhanced EID structure to be used for mobile >> environment. >> Nontheless, it is worthwhile to consider LISP as a promisng candidate in the >> disign of DMM, I think. >> >> By the way, as I already said in this IETF DMM ad hoc meeting, the urgent >> action item of DMM is >> to make one or more introductory I-Ds with WG consensus, which may include >> the problem statements and requirements for DMM, use cases/scenarios, and >> comparison matrix, etc. >> >> Regards, >> >> ************************* >> Seok-Joo Koh >> http://protocol.knu.ac.kr/ >> ************************* >>