Re: Multicast PS to requirements
"Seil Jeon" <[email protected]>
| Newsgroups | gmane.ietf.nemo |
|---|---|
| Message-ID | <[email protected]> |
Hi Luis, See inline, please. Regards, Seil From: [email protected] [mailto:[email protected]] On Behalf Of LUIS MIGUEL CONTRERAS MURILLO Sent: Tuesday, November 20, 2012 7:47 PM To: h chan Cc: [email protected] Subject: Re: [DMM] Multicast PS to requirements Hi Anthony, some comments in line Best regards, Luis De: [email protected] [mailto:[email protected]] En nombre de h chan Enviado el: martes, 20 de noviembre de 2012 18:51 Para: Sérgio Figueiredo; [email protected] Asunto: [DMM] Multicast PS to requirements Let us also use another thread to check for consensus of the PS from multimob. PS1 (revised): Non-optimal routes Routing via a centralized anchor often results in a longer route. The problem is especially manifested when accessing a local server or servers of a Content Delivery Network (CDN), or when receiving / sending IP multicast packets. [Luis>>] This is correct if the multicast content is locally available. However this could not be always the case for multicast listeners, for a number of reasons (for instance, conflict in the multicast address allocation between the Home Network and the DMM domain). >> I think you seem talking the opposite case. When all IP multicast is used locally regardless of IP mobility tunnel, it might avoid the PS1. PS6: Duplicate multicast traffic IP multicast distribution over architectures using IP mobility solutions may lead to convergence of duplicated multicast subscriptions towards the tunnels downstream entity (e.g. MAG in PMIPv6). Concretely, when multicast subscription for individual mobile nodes is coupled with mobility tunnels, duplicate multicast subscription(s) is prone to be received through different upstream paths. This problem is potentially more severe in a distributed mobility environment [draft-sfigueiredo-multimob-use-case-dmm-03]. [Luis>>] This seems not to be a problem of the IP mobility solutions handling multicast traffic with mobility tunnels in general, but a problem of considering several upstream paths ending on the same mobility access router as a consequence of extending tunnels from previousMAR to newMAR to forward the multicast traffic. >> Thanks to clarifying the issue correctly. Let me rephrase this again as following, IP multicast distribution over architectures making mobility tunnel endpoint towards an MN terminated on access router may lead to From: [email protected] [mailto:[email protected]] On Behalf Of Sérgio Figueiredo Sent: Monday, November 19, 2012 5:24 PM To: [email protected] Subject: Re: [DMM] Multicast requirements Hi Anthony, Thank you for trying to progress on this matter. I mostly agree with your analysis. As for the question you posed, first I would like to exactly understand what you mean with "multicast distribution scenario" in "DMM solutions should enable multicast services which are compatible with multicast distribution scenario, etc.". It seems like there is no major difference between this and the "DMM solutions should enable solutions to support multicast services." requirement? Aren't both expressing the need to enable multicast in a DMM solution? As you stated, "neglecting" the requirement 7.1 we proposed, leads to the PSs you referred. So, while 7.2 and 7.3 express the need for DMM solutions to allow deployment of multicast services, 7.1 concerns "how" IP multicast should be enabled in order to avoid the aforementioned PSs. The usage of the word "flexible"is explained by: "This flexibility enables different IP multicast flows with respect to a mobile host to be managed (e.g., subscribed, received and/or transmitted) using multiple endpoints". In other words, compatibility with "multicast distribution scenario" doesn't necessarily avoid PS1 and PS6. Thank you and best regards, Sérgio On 11/19/2012 10:28 PM, h chan wrote: There are 3 proposals for multicast requirements. Before comparing these proposals, let us understand what are the problems first. Two problem statements have been proposed: PS1 (revised): Non-optimal routes Routing via a centralized anchor often results in a longer route. The problem is especially manifested when accessing a local server or servers of a Content Delivery Network (CDN), or when receiving / sending IP multicast packets. PS6: Duplicate multicast traffic IP multicast distribution over architectures using IP mobility solutions may lead to convergence of duplicated multicast subscriptions towards the tunnels downstream entity (e.g. MAG in PMIPv6). Concretely, when multicast subscription for individual mobile nodes is coupled with mobility tunnels, duplicate multicast subscription(s) is prone to be received through different upstream paths. This problem is potentially more severe in a distributed mobility environment [draft-sfigueiredo-multimob-use-case-dmm-03]. Then, let us see whether all the 3 REQ proposals have the same intention. In the following, I rephrase them to highlight their similarities. REQ7.1: Flexible multicast distribution DMM solutions should be compatible with flexible multicast distribution scenario. Etc. The Motivation is to allow flexibility in (enable) multicast solutions to solve the problems PS1 and PS6 as explained in use cases already presented and discussed in multimob wg. REQ7.2: DMM solutions should enable solutions to support multicast traffic. (Original wording was "The DMM (unicast) solution MUST be specified in such a way that it can be extended to also support multicast traffic." I rephrase it to highlight the similarity with the other proposals and also changed the must to should.) REQ7.3: DMM solutions should enable solutions to support multicast services. Original wording was DMM solutions should support multicast services etc. Given that it is the scope of multimob and not dmm wg to provide the multicast solution, I think support here means enable solutions to be developed (by multimob). Similarity and subtle differences: Both REQ7.2 and REQ7.3 want to enable multicast services. Yet the explanation in REQ7.1 seems to indicate not just to enable any one multicast solution but also needs the flexibility in multicast solution. Not all multicast solutions are the same. Some of them results in PS1 or PS6. Are there any are essential differences between: In REQ7.1, DMM solutions should be compatible with flexible multicast distribution scenario, etc. Versus DMM solutions should enable multicast services which are compatible with multicast distribution scenario, etc. H Anthony Chan From: [email protected] [mailto:[email protected]] On Behalf Of Seil Jeon Sent: Monday, November 19, 2012 5:15 AM To: [email protected] Cc: [email protected] Subject: Re: [DMM] Multicast requirements Hi Pierrick, Ive many times thought about your question. I would say how effectively should we deploy/support multicast over distributed mobility rather than distributed mobile multicast. As a result, you can find this deployment use case and gap analysis at http://tools.ietf.org/html/draft-sfigueiredo-multimob-use-case-dmm-03 presented in multimob several times. In unicast DMM, main innovation is to distribute the anchor function at many access routers from single core. Following architectural concept of DMM, flexible multicast distribution is one of multicast requirement resulted from the draft described above. REQ8: Flexible multicast distribution "DMM solutions SHOULD be compatible with flexible multicast distribution scenarios. This flexibility enables different IP multicast flows with respect to a mobile host to be managed (e.g., subscribed, received and/or transmitted) using multiple endpoints". Motivation: The motivation for this requirement is to enable flexibility in multicast distribution. The multicast solution may therefore avoid having multicast-capable access routers being restricted to manage all IP multicast traffic relative to a host via a single endpoint (e.g. regular or tunnel interface), which would lead to the problems described in PS1 and PS6. PS6: Duplicate multicast traffic IP multicast distribution over architectures using IP mobility solutions may lead to convergence of duplicated multicast subscriptions towards the tunnels downstream entity (e.g. MAG in PMIPv6). Concretely, when multicast subscription for individual mobile nodes is coupled with mobility tunnels, duplicate multicast subscription(s) is prone to be received through different upstream paths. This problem is potentially more severe in a distributed mobility environment [draft-sfigueiredo-multimob-use-case-dmm-03]. Regards, Seil From: [email protected] [mailto:[email protected]] Sent: Monday, November 19, 2012 8:55 AM To: '[email protected]'; [email protected]; [email protected] Cc: [email protected] Subject: RE: [DMM] Multicast requirements Hi all, I tend to agree with Georgious, however I still do not figure out what is the use-case for distributed mobile multicast (other than academic considerations)? Can someone give concrete example? I havent real all messages from this thread. So, maybe I missed important points. BR, Pierrick De : [email protected] [mailto:[email protected]] De la part de [email protected] Envoyé : samedi 17 novembre 2012 13:01 À : [email protected]; [email protected] Cc : [email protected] Objet : Re: [DMM] Multicast requirements Hi all, I also agree that the DMM solution should somehow consider muticast deployment. However, I do not thnk that the DMM WG is the right WG to provide the multicast based DMM solution! One alternative solution will be to have a multicast requirement that emphasizes the need of having extensibility hooks (possibilities) that can be used later on by the multimob WG to provide a a multicast enabled DMM solution! So a requirement that specifies something like the following could be used for this purpose: "The DMM (unicast) solution MUST be specified in such a way that it can be extended to also support multicast traffic." Best regards, Georgios _____ Van: <mailto:[email protected]> [email protected] [[email protected]] namens Seil Jeon [[email protected]] Verzonden: vrijdag 16 november 2012 22:25 To: 'Zuniga, Juan Carlos' Cc: <mailto:[email protected]> [email protected] Onderwerp: Re: [DMM] Multicast requirements Hi Juan, I've been looked at changed flow of your proposed text but sorry now that my comment is posted. At first time, I couldn't make sure however, on hearing Stig's description, it seems quite reasonable at the first step, not giving any restrictions but leaving some-specific for the DMM solution it does not support multicast. On the other hand, it remains at a basic stage for the DMM solution to support multicast. So I think additional requirements need to be made for the DMM solution, accordingly. But of course, this should not also give any specific limitation and restriction but should be made towards the direction not limiting the benefits provided by distributed deployment. I hope to get more comments on this. Regards, Seil -----Original Message----- From: <mailto:[email protected]> [email protected] [ <mailto:[email protected]> mailto:[email protected]] On Behalf Of Zuniga, Juan Carlos Sent: Friday, November 16, 2012 8:14 PM To: Stig Venaas; <mailto:[email protected]> [email protected] Subject: Re: [DMM] Multicast requirements > -----Original Message----- > From: Stig Venaas [ <mailto:[email protected]> mailto:[email protected]] > Sent: Friday, November 16, 2012 3:01 PM > To: jouni korhonen > Cc: <mailto:[email protected]> [email protected]; Zuniga, Juan Carlos; Konstantinos Pentikousis; > Peter McCann; <mailto:[email protected]> [email protected] > Subject: Re: [DMM] Multicast requirements > > On 11/15/2012 3:17 AM, jouni korhonen wrote: > > > > On Nov 15, 2012, at 1:03 AM, Behcet Sarikaya wrote: > > > >> > >> I think we are reading too much into multicast and unicast should be > >> designed in an integrated manner. > >> > >> The fact is that multicast is considered as an area of > specialization, > >> it requires knowledge of very different protocols than we are > >> accustomed to in mobility. > > > > "Requirement: DMM solutions SHOULD support multicast services. If a > specific DMM solution does not support multicast services, an > explanation MUST be provided." > > This sounds good to me. > > The main thing I want to achieve is what was describes as motivation > earlier in this thread. Multicast should at least be considered when > looking into DMM solutions, and not just an afterthought once the > solution is decided. > > Stig [JCZ] I fully agree with this. That was the intention of the proposed text. Regards, Juan Carlos > > > To me that reads basically "do not break foundations for multicast > unless you have a valid & documented reason for it". If we look e.g. > into RFC625 multicast wording that is there very briefly but gives a > hint to a developer where to head to. That is the level I would expect > DMM documents should aim to. > > > > - Jouni > > > > > >> Let dmm deal with its current charter that does not include a word > of > >> multicast and if everything goes well we can come back and discuss > dmm > >> multicast. > >> > >> Regards, > >> > >> Behcet _______________________________________________ dmm mailing list <mailto:[email protected]> [email protected] <https://www.ietf.org/mailman/listinfo/dmm> https://www.ietf.org/mailman/listinfo/dmm _______________________________________________ dmm mailing list <mailto:[email protected]> [email protected] <https://www.ietf.org/mailman/listinfo/dmm> https://www.ietf.org/mailman/listinfo/dmm ____________________________________________________________________________ _____________________________________________ Ce message et ses pieces jointes peuvent contenir des informations confidentielles ou privilegiees et ne doivent donc pas etre diffuses, exploites ou copies sans autorisation. Si vous avez recu ce message par erreur, veuillez le signaler a l'expediteur et le detruire ainsi que les pieces jointes. Les messages electroniques etant susceptibles d'alteration, France Telecom - Orange decline toute responsabilite si ce message a ete altere, deforme ou falsifie. Merci. This message and its attachments may contain confidential or privileged information that may be protected by law; they should not be distributed, used or copied without authorisation. If you have received this email in error, please notify the sender and delete this message and its attachments. As emails may be altered, France Telecom - Orange is not liable for messages that have been modified, changed or falsified. Thank you. _______________________________________________ dmm mailing list [email protected] https://www.ietf.org/mailman/listinfo/dmm _____ Este mensaje se dirige exclusivamente a su destinatario. Puede consultar nuestra política de envío y recepción de correo electrónico en el enlace situado más abajo. This message is intended exclusively for its addressee. We only send and receive email on the basis of the terms set out at: http://www.tid.es/ES/PAGINAS/disclaimer.aspx _______________________________________________ dmm mailing list [email protected] https://www.ietf.org/mailman/listinfo/dmm