Re: Call for WG Adoption of a "current practices and gapanalysis" document

I prefer to take [2] draft-liu-dmm-best-practices-gap-analysis-01 as
the basis for wg document

Best Regards

Gang

2013/1/10, Shuai Gao <[email protected]>:
> Hi Folks,
> 	I support document [2] draft-liu-dmm-best-practices-gap-analysis-01 adopted
> as the WG draft.
>    Thank you.
>
> Best,
> Shuai
>
> 	
>
> ======= 2012-12-20 04:26:55 您在来信中写道：=======
>
>>Folks,
>>
>>We are unfortunately slipping our milestone, our (chairs) apologies for
>> that. The next step is to select a "current practices and gap analysis"
>> document to serve as the basis for the future WG document. We consider two
>> documents on this topic to choose from:
>>
>>[1] draft-zuniga-dmm-gap-analysis-02
>>[2] draft-liu-dmm-best-practices-gap-analysis-01
>>
>>and we as a WG need to decide which one is going to form the _basis_ for
>> the WG document.
>>
>>Please voice your preference either for [1] or for [2] on the mailing list.
>> We would appreciate if you can also provide a one-liner justification for
>> your selection. The chairs will determine if there is (rough) consensus
>> from active WG participants to proceed with selecting one document against
>> the other.
>>
>>The call starts today 19th Dec 2012 and ends by 10th Jan 2013. We have a
>> longer three week call now due the holiday season in between.
>>
>>- Jouni & Julien
>>_______________________________________________
>>dmm mailing list
>>[email protected]
>>https://www.ietf.org/mailman/listinfo/dmm
>
> = = = = = = = = = = = = = = = = = = = =
> 			
>
> 　　　　　　　　致
> 礼！
>
> 				
> Shuai Gao
> National Engineering Lab for Next Generation Internet Interconnection
> Devices
> Beijing Jiaotong University
> Beijing, China, 100044
> [email protected]
> 2013-01-10
>
> _______________________________________________
> dmm mailing list
> [email protected]
> https://www.ietf.org/mailman/listinfo/dmm
>
_______________________________________________
dmm mailing list
[email protected]
https://www.ietf.org/mailman/listinfo/dmm