Re: Fwd: I-D Action: draft-melnikov-pop3-over-tls-01.txt
Alexey Melnikov <[email protected]> Fri, 19 Aug 2011 12:21:14 +0100
| Newsgroups | gmane.ietf.pop3ext |
|---|---|
| Message-ID | <[email protected]> |
Hi Chris, My personal replies are (without consulting with Mykyta): Chris Newman wrote: >> From a technical viewpoint, I have two suggestions: > > Add to section 2.1: > > Servers that lack configuration to accept an X.509 client certificate > for > authentication purposes MUST NOT send a CertificateRequest handshake > to the client > during TLS negotiation. I am wondering whether this is actually possible to enforce using existing TLS stacks. I would rather not make this a MUST NOT level requirement if there are no APIs for this in, for example, OpenSSL. > Also in section 2.1: > > OLD: > SHALL use some other way to identify itself, e.g. USER and PASS > commands. > NEW: > MAY close the connection or try a different authentication mechanism > (e.g., USER > and PASS commands). > It's a spec error to disallow a client configuration that requires use > of client certificate authentication. For high security sites, a > password fallback is not acceptable. Yes, good point. > There are two general editorial problems: 1. issues that might cause > problems during last call. 2. the text could be simplified in several > places. > > Here are some editorial suggestions: > > In Abstract, OLD: > This document specifies how the Post Office Protocol, Version 3 > (POP3) may be secured with Transport Layer Security (TLS) protocol, > by establishing TLS layer connection directly before POP3 > transaction. It updates RFC 1939 and RFC 2595. > NEW: > This document specifies use of Transport Layer Security (TLS) on > port 995 to protect Post Office Protocol, Version 3. It updates RFC > 2595. > > Discussion: This no longer changes any rules in RFC 1939, so I see no > reason to update that specification -- perhaps best to avoid the > debates about "does this update spec XXX?" and "what does it mean for > a proposed standard to update a full standard?" during last call. I am Ok with this change. > Introduction (simplify) NEW: > The Post Office Protocol version 3 (POP3) [RFC1939], is an > application-layer protocol used by local e-mail clients to retrieve > e-mail from a remote server over a TCP/IP connection. It supports > a simple download-and-delete model for access to remote > mailboxes (also called a maildrop). > > As POP3 transfers sensitive information, there is a need > for privacy protection. Transport Layer Security (TLS) [RFC5246] and > its deprecated predecessor Secure Sockets Layer (SSL) [RFC6101] are > commonly > used for this purpose. > > [Discussion: I believe it's incorrect to state POP3 was intended to be > in the clear -- I recall someone, perhaps Marshall Rose telling me the > intention was to use whatever privacy mechanism the lower layers > defined (e.g. IPsec). SSL/TLS became necessary because IPsec wasn't > sufficiently deployable. Also it's inaccurate to say TLS is the only > mechanism -- that will just annoy security geeks during last call who > have used KPOP and IPsec]. Ok. > Two mechanisms to protect POP3 using TLS have been deployed. One > negotiates > TLS within POP3 (also known as upgrading to TLS) [RFC2595]. The other > starts TLS prior to starting the POP3 application layer. The latter > mechanism (called "POP3S" throughout this document) has not been > previously > specified in an RFC. This document specifies POP3S. > > RFC 6186 [RFC6186] specifies use of DNS SRV records [RFC2782] > to locate email access services. It supports both POP3S and POP3 > upgraded > to TLS. For more information, refer to Section 3.3 of RFC 6186. > > Section 2.1: > > to verify server's certificate. Upon successful negotiation all data > ^ > the > ... > SASL EXTERNAL mechanism, which is defined in Appendix A of RFC 4422 > ^ > the > > authentication using X.509 certificate MUST support SASL EXTERNAl > ^^^^^^^^^^^ ^^^^^^^^ > certificates EXTERNAL > > > convention on using X.509 certificate for authentication, the client > ^^^^^^^^^^^ > certificates Yes. > Suggest removing this: > Anyway, as soon as the client authenticates itself, and the server > verifies its credentials, they both enter TRANSACTION state and begin > exchanging POP commands and replies. > or rewording as: > As with POP3, POP3S enters TRANSACTION state after the server sends > a +OK response to an authentication command. I like your rewording. > OLD: > Please note that per RFC 6176 [RFC6176], neither clients nor servers > must perform attempts to negotiate use of SSL 2.0. > NEW: > SSL 2.0 MUST NOT be used for POP3S, see RFC 6176 [RFC6176] for details. Ok. > Section 2.3: > > terminate its part of connection without waiting a response from the > ^ > for > Section 2.4 (simplify): > > POP3S uses port 995. Section 4 updates the IANA registration for > port 995. > > Section 2.5 (simplify/clarify): > > Section 7 of RFC 2595 [RFC 2595] expresses concerns about use of a > separate > port. The concern about port usage does not apply as port 995 was > previously > registered. RFC 6186 mitigates the other concerns. The usefulness of > POP3S > outweighs the mitigated flaws so the statement in section 7 of RFC 2595 > discouraging use of pop3s is rescinded. > > Discussion: this makes it is clear why RFC 2595 is amended but does > not declare the advice in RFC 2595 invalid, thus avoiding the entire > debate about whether separate-port or upgrade-to-TLS is better. Best > to avoid unnecessary debates when getting a spec standardized... Ok with me. > Section 3 (simplify): > > POP3S uses TLS [RFC5246] to provide protection from eavesdropping and > tampering with POP3 protocol content. The security considerations of > TLS [RFC5246] > and those related to server identity verification [RFC6125] > [I-D.melnikov-email-tls-certs] apply. Sure.